Blodgett SG3240 Serie Manual Del Operario página 15

STANDARD CONVEYOR ASSEMBLY
Conveyor Racks
1. Slide the drive side conveyor support rack
onto the conveyor support angles.
NOTE: The sprocket on the conveyor rack must
be inside the electrical box after being
pushed into the oven. See View A.
2. Install the drive chain around the drive motor
sprocket and the sprocket on the conveyor
rack. Pull the conveyor rack forward to tighten
the chain.
3. Secure the conveyor using the conveyor locat-
ing pin. Install the pin from the inside of the elec-
See View A
Drive Side Conveyor Rack
trical box, through the conveyor bracket and
into the conveyor rack. See View A.
4. Slide the idle side conveyor rack onto the con-
veyor support angles until it touches the drive
side conveyor rack.
NOTE: If the mounting hole cannot be lined up or
the chain is too loose, the drive motor will
need to be repositioned.
See View A
Figure 9
13
Installation
Oven Assembly
View A
Sprocket
Locating
Pin
Conveyor
Bracket
Idle Side
Conveyor Rack