Technical Information; General Safety Advice; Your Working Area; Electrical Safety - Parkside PFS 710 A Instrucciones De Utilización Y De Seguridad

technical information

Q
Rated voltage: 230 V ~ 50 Hz
Nom. power input: 710 W
Nom. no-load speed: n
Blade stroke: 28 mm
Max. cutting width: Wood 195 mm
Protection class: II /
noise and vibration data:
Values determined in accordance with EN 60745
The sound pressure level (A-weighted) of the
device is typically 86 dB(A). Uncertainty K=3 dB.
The sound level while working can exceed 99 dB (A).
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
Uncertainty K = 1,5 m / s
WArnIng!
The vibration level given in these
instructions has been measured in accordance with a
standardised measurement procedure specified in
EN 60745 and can be used to compare devices.
Different uses of the device give rise to different vibra-
tion levels and in many cases they may exceed the
values given in these instructions. It is easy to underes-
timate the vibration load if the electrical power tool is
used regularly in particular circumstances.
note: If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of working, you should also take into ac-
count the intervening periods of time when the de-
vice is switched off or is running but is not actually
in use. This can result in a much lower vibration
load over the whole of the period of working.
500 - 2600 min -1
0
= 6,303 m / s
2
2
Introduction / General safety advice
PFS 710 A KH 3189
230 V ~ 50 Hz · 710 W
n 500 - 2600 min
-1
0
Date of manufacture: 02-2008
Kompernaß GmbH · D- 44867 Bochum · www.kompernass.com

general safety advice

Q
J
AttEntIOn! Please read all the instructions
and advice. Failure to observe the instructions
and advice given below may result in electric
shock, fire and / or serious injury.
MAKE SURE THAT YOU KEEP THESE INSTRUC-
TIONS AND SAFETY ADVICE IN A SAFE PLACE.

1. Your working area

a) Keep your working area clean and
clutter-free. Untidy or poorly lit working
areas can lead to accidents.
Do not work with the device
b)
in potentially explosive en-
vironments in which there
are inflammable liquids, gases or
dusts. Electrical power tools create sparks,
which can ignite dusts or fumes.
Keep children and other people
c)
away while you are operating
the electrical tool. Distractions can
cause you to lose control of the device.

2. Electrical safety

a) the mains plug on the device must match
the mains socket. the plug must not be
modified in any way. Do not use an
adapter plug with devices fitted with a
protective earth. Unmodified plugs and
matching sockets reduce the risk of electric shock.
GB/MT 25