Open the Case.
Use the provided O-ring remover as described below.
Insert the hook section below the buckle lock/unlock lever.
Slowly pull the O-ring remover.
If the O-ring remover is not available, push the buckle lock/unlock
lever from the left and right with your thumb and index finger, and
pull up the lever gently.
Insert the digital camera.
Make sure that the digital camera is turned OFF. Pull up the mode dial
knob on the front lid of the Case and gently insert the digital camera into
the Case, taking care that the projecting part of the camera's zoom lever
fits into the recessed part of the Case's zoom lever section.
CAUTION
: • Confirm that the projecting part of the zoom lever of
the digital camera is set securely to the zoom lever
notch on the inside of the Case. When the setting is
not secure, the loading of the digital camera is not
complete and closing of the rear lid of the Case may
not be possible or zoom may not function even when
the zoom lever is operated.
• Insufficient sealing will cause water leakage.
Mode dial
knob
E-19