Markings And Symbols - Parker LCMS64 Guia Del Usuario

1.1 Markings and Symbols

The following markings and international symbols are used on the equipment or within this manual:
WARNING
GENERATOR MUST BE SHUT
DOWN AND DEPRESSURISED
BEFORE PERFORMING
ANY MAINTENANCE
(REFER TO MANUAL)
DANGER
DISCONNECT THE
MAINS SUPPLY BEFORE
REMOVING THIS COVER
NITROGEN (N )
2
DO NOT BREATHE
NON-FLAMMABLE
Asphyxiant in high
COMPRESSED
concentrations. No odour
Slightly lighter than air.
GAS
Ensure adequate ventilation.
Breathing 100% nitrogen will produce
immediate unconsciousness and death
due to lack of oxygen.
LISTED
LABORATORY
EQUIPMENT 84NA
2
Caution, Read the User manual.
Risk of electric shock.
Highlights actions or procedures which, if not
performed correctly, may lead to personal
injury or death.
Highlights actions or procedures which, if not
performed correctly, may lead to damage to
this product.
WARNING
The generator must be shut down and
depressurised before performing any
maintenance.
(REFER TO MANUAL)
DANGER
Disconnect the mains supply before removing
this cover.
NITROGEN (N2),
DO NOT BREATHE
Asphyxiant in high concentrations. No odour. Slightly lighter than air. Ensure adequate ventilation. Breathing 100% nitrogen
will produce immediate unconsciousness and death due to lack of oxygen.
NON-FLAMMABLE COMPRESSED GAS
This product has been certified by Underwriters Laboratories
Highlights actions or procedures which, if not
performed correctly, could lead to electric
shock.
When disposing of old parts always follow local
waste disposal regulations.
Conformité Européenne
Waste electrical and electronic equipment
should not be disposed of with municipal
waste.
DANGER
DANGER
Live terminals are enclosed.
LIVE TERMINALS
ENCLOSED
Disconnect the mains supply before removing
DISCONNECT THE
MAINS SUPPLY BEFORE
the cover.
REMOVING THIS COVER
Prior to powering up the generator, remove the
rear access panel from the generator and
unscrew the M8x20mm packing bolt from each
compressor mounting assembly using a 13mm
spanner.
When complete refit the rear access panel and
continue with the installation.
Failure to do this will cause irreparable
damage to the generator and will invalidate the
warranty
®
.