Remote Control Unit - Denon AVR-3802 Instrucciones De Operación

l_El]!_ql]
This button can be pressed at any time during the system setup process to complete the process
At the System Setup Menu, press the SYSTEM SETUP button
The changed settings are entered and the on-screen display turns off
• On-screen display signals
Signa}s i/put o the AVR 3802 ©/screen display signa output
VIDEO sigllal input Swideo signa] VDEO MONITOR OUT vdeo S video MONITOR OUT video
ack (ye low} input jack signal output jack {yelow} signal output ack
1 x x ( )
2 0 x ( x
3 x ( x O
4
O O x O
{(_: Signa} X: NOsignal} (O: O/ screen signals output X: On screen s gnals not output)
NOTES:
• The on-screen dsplay signals are not output from the color difference (component) video sgnal
MONITOR OUT jacks
• For 4 above, the on-screen display signals are output to the VIDEO MONITOR OUT video signal output
jack (yellow) if the monitor TV is not connected to the S-video MONITOR OUT video signal output jack
[] REMOTE CONTROL UNIT
• The included remote control unit (RC-884) can be used to operate not only the AVR-3802 but other remote
control compatible DENON components as well In addtion, the memory contains the control signals for
other remote control units, so it can be used to operate non-Denon remote control compat ble products
'il Remove the remote control unit's rear cover
"/2 Set three R6P/AA batteries in the battery
compartment in the indicated direction
@ Put the rear cover back on
Notes on Batteries
• Use R6P/AA batteries in the remote control unit
• The batteries should be replaced with new ones
approximately once a year, though this depends on
the frequency of usage
• Even f less than a year has passed, replace the
batteries with new ones f the set does not operate
even when the remole control unit s operated
nearby the set {The nduded battery is only for
verifying operation Replace it with a new battery as
soon as poss ble )
• When nserting the battedesr be sure to do so in the
proper direction, following the "(_," and "(Y" marks
m the battery compartment
• Tu prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old
one
• Do not use two different types of batteries
• Do not short-circuit, disassembler heat or
dispose of battedes in flames
• Remove the batteries from the remote control unit
when you do not plan to use it for an extended
period of time
• If the battery fluid should leak, carefully wipe the
fluid off the inside of the battery compartment and
insert new batteries
• When replacing the batteries, have the new
batteres ready and insert them as quickly as
possible
IL_'_t* *t=, - ,t ,1_
Approx 1 m
• Point the remote control unit at the remote sensor
on the main unit as shown on the diagram
• The remote control unit can be used from a straight
d stance of approximately 7 meters from the main
unit, but this d stance will be shorter if there are
obstacles in the way or if the remote control unit is
not pointed directly at the remote sensor
• The remo'_e control unit can be operated at a
horizontal angle of up to 30 degrees with respect to
the remote sensor
NOTES:
• It may be difficult to operate the remote control
unit if the remote sensor s exposed to direct
sunlight or strong artif cial light
• Do not press buttons on tile main unit and remote
control unit simultaneously Doing so may result in
malfunction
• Neon signs or other devices emitting pulse-type
nose nearby may result in malfunction, so keep
the set as far away from such devices as possible
16