Denon AVR-3802 Instrucciones De Operación página 20

l_[=]]_S]g
5
6
Use the , and J cursor buttons to select the
mode for the button at which the system call
signaEs are to be registered, then press the
ENTER button
"SELECT KEY" is displayed Press
the button at which the system call
signaEs are
to be
registered,
then
press the ENTER button
• "ENTER KEYS" is dsplayed, then
the mode display appears
I Press the mode selector button according to 4
the butto_ with the remote control signals to
be registered
_2_ Press the buttons with the remote control
signals to be reg stered one at a tme
Press the ENTER button
• "COMPLETE" appears on the
remote
control
unit's
display
and
regEstrat on is completed
NOTES:
• The remote control signals of the buttons pressed while registering the system call sig_lals are emitted, so
be careful not to operate the components accidentally {cover the remote sensors, for example)
• if you exceed the number of signals that can be registered, "FULL" appears on the remote control unit's
display and only the number of signals that can be registered are registered (up to 29 operat ons)
(3) Using the system call function
I
Press the button at which the system call signab have been stored
• The stored signals are transmitted successively
Use the , and _ cursor buttons to display
r'RESET SYS" on the remote control unit, then
press the ENTER button
• "SYS SEL" appears on the remote control
unit's display
The remote control unit's display switches
as shown below each time the and
cursor buttons are pressed
5
Press the {, and cursor butto_ls
to select the system call setting
to be reset
_4 The remote control unit's display switches
as shown below each time the and
cursor buttons are pressed
F ¸,
l,= To reset CALL 1 or CALL 2, select "SYS
CALL 1" or SYS CALL 2", then press the
ENTER button
"_2 Tu reset system call settings regstered at
other buttons, select "SYS MODE", press
the ENTER butto_, press the mode button at
which the button is registered, then press
the ENTER button again
6
"CONFIRM" is displayed To reset the setting,
press the ENTER button while "CONFIRM" is
displayed
• "SYS SEL" appears on the remote control
unit's display
I-'_]
(1) Resetting the system call buttons
Press the power ON/SOURCE butto_ and the
OFF button at the same time
• "SET UP" appears on the remote control
unit's display
2
Press the ENTER button
Use the and ' cursor buttons to dsplay
"RESET" on the remote control unit, then press
the ENTER button¸
1
3,4,5
2,3,4,5,6
{2) Resetting the preset memory
Press the power ON/SOURCE button and the
OFF butto_ at the same time
• "SET UP" appears on the remote control
unit's display
2
Press the ENTER butto_
Use the and cursor butto_ls to display
"RESET" on the remote control unit, then press
the ENTER button¸
1
3,4,5
2,3, 4, 6,7
2O