Denon AVR-3802 Instrucciones De Operación página 24

1 Set the external input (EXT IN) mode
Press the EXT IN to switch the external input
EXTIN
%
M_ir wl t_ (Rer_l_e control uni_)
Once this is selected, the input signals
connected to the PL (front left), PR )front right),
C (center), SL (surround left}, SR (surround
rght), SBL (surround back left) and SBR
)surround back right) channels of the EXT IN
jacks are output directly to the front {left and
right), center, surround left and right) and
surround back (left and rght) speaker systems
as well as the pre-out jacks without passing
through the surround circuitry
In addition, the signal input to the SW
(subwoofer) jack is output to the PRE OUT
SUBWOOFER jack
2
Cancelling the external input mode
To cancel the external nput (EXT IN) setting,
press the nput mode (AUTO, PCM, DTS) or
ANALOG button to switch to the desired input
mode (See page 23)
{Man u/it) Re 1>te contro u/it)
• When the input mode is set to the external input
(EXT IN), the play mode {DIRECT, STEREO,
DQLBY/DTS SURROUND, 5/7CH STEREO, WIDE
SCREEN or DSP SIMULATION) cannot be set
CoL
[°I =°=
2 1
NOTES:
• In play modes other than the external input
mode, the signals connected to these jacks
cannot be played In addition, signals cannot be
output from channels not connected to the input
iacks
• The external input mode can be set for any input
source Tu watch video while listening to sound,
select the input source to which the video signal
is connected, then set this mode
[1] Adjusting the sound quality (TONE)
The tone control function will not work in the Direct mode
The tone switches as follows each time the
TONE CONTROL button is pressed
BASS _ TREBLE
Mdh Jr1)
With the name of the volume to ,,,_
be adjusted selected, turn the {0 !
SELECT knob to adiust the level
MJn Jni)
• Tu increase the bass or treble: Turn the control
clockwise (The bass or treble sound can be
increased toupto +12dB nstepsof 2dB)
• Tu decrease the bass or treble: Tdrn the
control clockwise (The bass or treble sound
can be decreased to up to -12 dB in steps of
2 dB)
COL-:::
oooo *
3 21
If you do not want the bass and treble to be
adjusted, turn o_ the to_e defeat mode
_oN__;FEAT
The signals do not pass
through the bass and treble
adjustment circuits, providi_g
higher quality sound
Mah /i)
[2] Listening over headphones
Connect the headphones to Pt4oN_s
the PHONESiackof the front @
panel
Q_ _1
Press the OUTPUT button to play the sound
over the headphones only
• The output to the speaker and pre-out jacks is
turned off and no sound is produced from the
speakers
Caution: Switching off the power of the unit and
the unit wil cancel the settings
u_ _0_
I
NOTE:
To prevent hearing Joss, do not raise the volume level
excessively when using headphones
[3] Turning the sound off temporarily (MUTING}
Use this to turn off the audio
output temporarily
Press the MUTING button
Ca_cellng MUTING (Rerloecon_ol jni)
mode
Press the MUTING button again
24