Remote Control Unit; Using The Remote Control Unit - Denon AVC-A1SR Instrucciones De Operación

4
Press jog stick "ENTER" to finalize the setting and exit the system setup mode.
When the setup lock function is activated, the settings listed below cannot be changed,
and "Setup Locked" is displayed when related buttons are operated.
• System setup settings
• Surround parameter settings
• Tone control settings
• Channel level settings (including test tones)
To unlock, press the System Setup button again and display the Setup Lock screen, then
select "OFF" and press jog stick "ENTER".
This completes system setup. Once these settings are made, there is no need to change them
unless different AV components are connected or the speakers are repositioned.
After completing system setup
This button can be pressed at any time during the system setup process to complete the process.
1
At the System Setup Menu, press the SYSTEM SETUP button.
The changed settings are entered and the on-screen display turns off.
Finally set the remote control unit (RC-871) display time setting to a time that is short but long enough that
operation is possible. (page 10)
• On-screen display signals
Signals input to the AVC-A1SR
VIDEO signal input S-video signal input
jack (yellow) jack
1
C E
2
E C
3
C C
( C : Signal E : No signal)
NOTE:
• When a component video signal is input and when the "Video Input Mode" is set to the component fixed
mode at system setup, the on-screen display is only displayed when the System Setup, Surround
Parameters and On Screen buttons are operated.
On-screen display signal output (MONITOR output jacks)
VIDEO signal output S-video signal Component video
jack (yellow) output jack signal output jack
C C
C C
E C
( C : On-screen signals output E : On-screen signals not output)
8

REMOTE CONTROL UNIT

• The included remote control unit (RC-871) can be used to operate not only the AVC-A1SR but other remote
control compatible DENON components as well. Furthermore, it is equipped with a function for learning the
control signals of remote control units of other manufacturers, so it can also be used to operate non-DENON
remote control compatible video components.
• For details, refer to the separate (supplied) RC-871 operating instructions.

Using the remote control unit

30°
Approx. 7 m
C
C
C
• Point the remote control unit at the remote sensor
on the main unit as shown on the diagram.
• The remote control unit can be used from a straight
distance of approximately 7 meters/22 feet from
the main unit, but this distance will be shorter if
there are obstacles in the way or if the remote
control unit is not pointed directly at the remote
sensor.
• The remote control unit can be operated at a
horizontal angle of up to 30 degrees with respect to
the remote sensor.
30°
NOTES:
• It may be difficult to operate the remote control
unit if the remote sensor is exposed to direct
sunlight or strong artificial light.
• Do not press buttons on the main unit and remote
control unit simultaneously. Doing so may result in
malfunction.
• Neon signs or other devices emitting pulse-type
noise nearby may result in malfunction, so keep
the set as far away from such devices as possible.
ENGLISH
19