Using The Remote Control Unit - Denon AVR-1803 Instrucciones De Operación

FRONT SPEAKER SYSTEMS
( L ) ( R )
( A )
Connection jack for subwoofer with
SURROUND BACK SPEAKER
built-in amplifier (super woofer), etc.
SYSTEMS
To achieve Dolby Digital playback
effect, use a unit that can
The same signal is output
sufficiently reproduce frequencies
simultaneously to the SURR.
of under 80 Hz.
BACK A and B terminals.
• Precautions when connecting speakers
If a speaker is placed near a TV or video monitor, the colors on the screen may
be disturbed by the speaker's magnetism. If this should happen, move the
speaker away to a position where it does not have this effect.
CENTER SPEAKER SYSTEMS
( B ) ( L ) ( R )
SURROUND SPEAKER SYSTEMS

9 USING THE REMOTE CONTROL UNIT

Following the procedure outlined below, insert the batteries before using the remote control unit.
Range of operation of the remote control unit
30°
30°
Approx. 7 m
Inserting the batteries
q Press as shown by the arrow w Insert the R6P/AA batteries properly,
and slide off. as shown on the diagram.
NOTES:
• Use only R6P/AA batteries for replacement.
• Be sure the polarities are correct. (See the illustration inside the battery compartment.)
• Remove the batteries if the remote control transmitter will not be used for an extended period of time.
• If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact
with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.
• Have replacement batteries on hand so that the old batteries can be replaced as quickly as possible when the
time comes.
• Even if less than a year has passed, replace the batteries with new ones if the set does not operate even when
the remote control unit is operated nearby the set. (The included battery is only for verifying operation.
Replace it with a new battery as soon as possible.)
ENGLISH
Point the remote control unit at the remote control
sensor as shown on the diagram at the left.
NOTES:
• The remote control unit can be used from a straight
distance of approximately 7 meters, but this distance
will shorten or operation will become difficult if there
are obstacles between the remote control unit and
the remote control sensor, if the remote control
sensor is exposed to direct sunlight or other strong
light, or if operated from an angle.
• Neon signs or other devices emitting pulse-type noise
nearby may result in malfunction, so keep the set as
far away from such devices as possible.
e Close the lid.
9