Prepare; Place Batteries In Smartdoor - Petsafe SmartDoor PPA11-10711 Guía Para El Usuario

SmartDoor – The SmartDoor
™
unique SmartKey code for selective pet entry and exit.
™
SmartDoor Flap – The SmartDoor
™
sun protection.
Antenna - The antenna is located inside the SmartDoor
SmartKey . The SmartKey
™
the unique code to be read.
Radio-frequency Interference – Radio-frequency interference is due to radio-frequency signals
from other household appliances or common electronic products that negatively affect the ability
of the SmartDoor
™
can come from a variety of sources. Interference can be minimal, constant or ever changing based
on usage and closeness of other electronic household items during SmartDoor
recommended that household appliances and common electronic products be placed at least two
feet (60 cm) away from the SmartDoor
Sensitivity Knob – Conveniently placed on the interior frame of the SmartDoor
knob. You can easily adjust the SmartDoor
and environmental factors to optimize SmartDoor
Sensitivity Level – The level of sensitivity can be adjusted by turning the sensitivity knob
from minimum to maximum, depending on radio-frequency interference and the SmartDoor
application and/or location. Pre-set from the factory, the sensitivity level should not be adjusted
until after installation. For example, the sensitivity level may need to be increased if the
SmartDoor is installed in a metal door. Reference page 10 for more information on how to
™
adjust sensitivity.
MODE-RESET Button – Easily select an Operational Mode on your SmartDoor
MODE-RESET button to cycle through selections of operation: LOCKED, UNLOCKED or AUTOMATIC.
LEARN Button – The LEARN button programs a SmartKey
SmartDoor . (One) SmartKey
™
SmartKeys (each sold separately) to one SmartDoor
™
Operational Modes
LOCKED Mode – The SmartDoor
UNLOCKED Mode – The SmartDoor
AUTOMATIC Mode – The SmartDoor
the pet wearing a programmed SmartKey
Battery Compartment – The battery compartment is located on the Interior Frame and requires
(four) D-cell (LR20) batteries. Installation mounting screws, key ring, SmartKey
RFA-67 battery are all located inside the battery box during shipping for your convenience.
RFA-67 Battery – The RFA-67 battery powers the SmartKey
RFA-67 batteries are available at retailers, or by calling PetSafe
www.petsafe.net. Typical life of the RFA-67 is approximately six months.
Outer Frame Size – Overall pet door dimensions
Cut-out Size – Opening cut in homeowner's door for proper fi t and pet door installation
Replacement Flap Size – Overall fl ap size when removed from pet door
Flap Opening Size – Usable fl ap space for pet to enter and exit through the pet door
Interior Frame – Pet door frame on the inside of home
Exterior Frame – Pet door frame on the outside of home

PREPARE

Preparing Your SmartDoor
DO NOT PROCEED WITH CUT-OUT OR INSTALLATION UNTIL ALL STEPS A-D BELOW
HAVE BEEN COMPLETED. DO NOT REMOVE SENSITIVITY STICKER UNTIL AFTER
INSTALLATION.
is an intelligent receiver using an internal antenna to pick up a
™
fl ap is a weather resistant, plastic fl ap with UV
™
must be located within a certain proximity of the antenna in order for
™
to receive a signal from a SmartKey
comes programmed and ready to use. You may program up to fi ve
™
fl ap is locked and does not allow entry or exit for any pet.
™
™
. Radio-frequency interference or "noise"
™
's location.
™
's sensitivity, taking into account common interferences
™
operation.
™
.
™
fl ap is unlocked and allows entry and exit for all pets.
™
fl ap is electronically locked and allows entry and exit for
™
.
™
™
www.petsafe.net
and receives radio signals from the
's unique code to be read by the
™
and is replaceable. Additional
™
Customer Care Center or visiting
®
's operation. It is
™
is the sensitivity
™
's
™
by holding the
™
and the (one)
™
5