Check Smartdoor ™ Location Before Installation; Install; Installing Your Smartdoor; Determine Pet Door Location - Petsafe SmartDoor PPA11-10711 Guía Para El Usuario

AUTOMATIC MODE – Allows entry and exit for a pet wearing a programmed SmartKey
To set: hold the MODE-RESET button until the yellow light illuminates and release when
selected. Five SmartKeys
during AUTOMATIC MODE.
NOTE:
If at any time the red light remains illuminated, replace with a set of fresh batteries. If
that does not reset the red light, please call our Customer Care Center for additional help.
If any part of step C was unsuccessful, please call our Customer Care Center for additional help.
D. Check SmartDoor
DO NOT REMOVE SENSITIVITY STICKER BEFORE INSTALLING THE SMARTDOOR
Prior to installation, it is recommended to check that the SmartDoor
intended location or application to guard against possible severe radio-frequency interference.
Household appliances and common electronic products should be located at least two feet (60 cm)
away from the SmartDoor
appliances or common electronic products will negatively affect the ability of the SmartDoor
receive a SmartKey
wireless telephones, microwaves, televisions, garage door openers, hand-held electronic devices
(such as cell phones, game stations and remote controls).
The sticker placed over the sensitivity knob should not be removed until after installation, as the
factory default sensitivity setting is positioned at the optimal level for most installations.
It is recommended to install SmartDoor
Temperature Range: -5˚ F to 180˚ F (-20.5˚ C to 82˚ C). Operating Humidity Range: 0 to 99.9%.
• To check if SmartDoor
and application, place SmartDoor
upright position. After performing steps A-C, now set the SmartDoor
hold the SmartKey
about three seconds. Remember, the SmartKey
the SmartDoor .
™
NOTE:
If there are existing SmartKeys
batteries while performing step D except the SmartKey
If the SmartDoor does not unlock, move the SmartDoor
™
once more. If the SmartDoor
Care Center for additional help.
When steps A-D are completed and all are successful, your SmartDoor

INSTALL

Installing Your SmartDoor

Determine Pet Door Location

Step
1
1A
can be programmed to one SmartDoor
™
Location Before Installation
™
's location. Radio-frequency interference detected from other household
™
signal. Typical appliances and products to consider are laptop computers, ™
's radio-frequency technology will operate properly in desired location
™
directly in front of and against the door or application in the
™
directly in front of the SmartDoor
™
's location test above was unsuccessful, please call our Customer
™
1B
in a location where direct wind is not a factor. Operating
™
. The SmartDoor
™
included in the kit is already programmed to
™
in the household, remove all (RFA-67)
™
™
™
™
1A Measure and mark your pet's shoulder
height on the door.
1B Determine location for the pet door. Draw
a vertical center line through the shoulder
height line using a level.
If homeowner's door or other application is
not level, the pet door must be marked level to
swing properly.
www.petsafe.net
for selective entry and exit
™
will operate properly in the
™
in AUTOMATIC mode and
™
fl ap should unlock in
™
included with the SmartDoor
to another location and follow steps A-D
is ready for installation.
™
NOTICE
.
™
.
™
to
™
.
™
7