Operation - WEG CFW-11 Guía De Instalación, Configuración Y Operación

1 2
A
B
C
1 2 3
D
NOTE!
E
For detailed information about network installation, parameterization and
operation of the inverter using the Profibus DP interface, see the Profibus DP
Communication Manual for the CFW-11 or CFW70X. These manuals, as well
as the "GSD" configuration files, are in the CD-ROM that goes with the inverter.
NOTE!
For CFW-11 inverters the expansion module Profibus DP can be used only with
software version V2.00 or higher.
NOTE!
With the CFW70X frequency inverter, it is not possible to use the DB9 connector,
because of a mechanical incompatibility with the control board top XC2 plug-in
terminal strip.

3. OPERATION

Step 1: After installing the accessory, energize the drive.
Step 2: Check to see if the accessory was correctly installed, observing the value of
parameter P0028, according to the accessory used:
- RS-232-01:
- RS-485-01:
- CAN-01:
- CAN/RS-485-01:
- PROFIBUSDP-01:
Table 4: Connector DB9 (XC6) pins for Profibus DP interface
Pin
1
2
3
3 4
4
5
6
7
8
9
Frame
Table 5: Profibus interface 3 line plug-in connector (XC7) pinout
Pin
1
2
3
MASSA BRUTA/GROSS WEIGHT
ECM LOC RESUMO DE MODIFICAÇÕES/SUMMARY OF MODIFICATIONS
EXEC
VERIF/CHECKED
LIBER/RELEASED
DT LIBER/REL
Propriedade da WEG. Proibida reprodução sem autorização prévia./WEG's property. Forbidden reproduction without previous authorization.
P0028 = CCXXh
P0028 = CEXXh
P0028 = CDXXh
P0028 = CAXXh
P0028 = C9XXh
Name Function
- Reserved (do not connect)
- Reserved (do not connect)
B Signal B (red)
5 6
- Reserved (do not connect)
Profibus interface isolated
GND
reference
5V output isolated from the
+5V
Profibus interface
- Reserved (do not connect)
A Signal A (green)
- Reserved (do not connect)
Shield Protective earth
Name Function
A Signal A (green)
B Signal B (red)
Shield Protective earth
MASSA LÍQUIDA/NET WEIGHT ESCALA/SCALE
EXEC DATA/DATE VER
VERIF/CHECKED LIBER/RELEASED
FOL/SHEET
1 1
7