Electromagnetic Compliance (Emc) Information; Environmental Conditions; Materials - Invacare Birdie Manual Del Usuario

Invacare®Birdie™
10.3 Electromagnetic compliance (EMC)
information
Medical Electrical Equipment needs to be installed and used according
to the EMC information in this manual.
This equipment has been tested and found to comply with EMC limits
specified by IEC/EN 60601-1-2 for Class B equipment.
Portable and mobile RF communications equipment can affect the
operation of this equipment.
Other devices may experience interference from even the low levels
of electromagnetic emissions permitted by the above standard. To
determine if the emissions from the lift is causing the interference,
run and stop running the lift. If the interference with the other device
operation stops, then the lift is causing the interference. In such rare
cases, interference may be reduced or corrected by the following:
•
Reposition, relocate, or increase the separation between the
devices.
Contact Invacare for any additional EMC information or EMC tables
for the device environment.

10.4 Environmental conditions

Storage and
transportation
Temperature -10°C to +50°C
Relative humidity 20% to 75%
Atmospheric
pressure
42
Operation
+5°C to +40°C
20% to 90% at 30°C,
not condensing
700 hPa to 1060 hPa

10.5 Materials

Component
Base, legs, mast and boom
Hanger bar
Actuator housing, hand control,
mast protector, casters and
other plastic parts
Bolts and nuts
Material
Steel, powder coated
Steel, powder coated and foam
material according to marking
(PA, PP, PE)
Steel, rust protected, zinc-plated
1575480-A