Tabla de contenido
Idiomas disponibles
Idiomas disponibles
www.trapp.com.br
Distance check between knives
Every time the blades are removed (disassembly
/ reassembly) before starting the machine again,
check and adjust the distance between the knife
and the counter cutting;
The adjustment should be done with the distance
between knives as the machine:
TRR 180/190 e 280 = 3 mm +/- 0.4 mm
TRR 250/260 = 2.5 mm +/- 0.4 mm
TRR 180/190 =
3 mm +/- 0,4 mm
TRR 250/260 =
2,5 mm +/- 0,4 mm
TRR 280 =
3 mm +/- 0,4 mm
Gasoline engine
To change motor oil
Establish the temperature range foreseen before
next change of oil. The heated oil makes it facilitates
its flow during the change.
Equipment must be on a flat and level surface.
Collect used oil in proper container.
As shown in Figure 12, carefully unscrew the oil
drain plug (1) to avoid possible accidents, such as
burns.
Blade
Counter
blade
Image
merely illustrative
Figure 12
Attention!
If motor is hot when changing oil, be
careful to remove oil container. Hot oil
is released with more pressure, and may
cause burns.
1
When oil has been fully drained, screw back oil
container (1).
As shown in Figure 13, remove the dipstick (2) and
fill the crankcase with the oil. When completed,
close it again, according to the amount indicated in
the engine manual.
2
1
2
Image
merely illustrative
Figure 13
1
73
Tabla de contenido
