To Pair The Handheld Remote And Receiver Collar; Training Guide; Test The Remote Trainer - Petsafe VT-100 Manual De Funcionamiento

STEP 4

To Pair the Handheld Remote and Receiver Collar

If your Receiver Collar does not beep when the Tone Button of the Handheld Remote is pressed, or if the
Receiver Collar is not responding to the Handheld Remote, follow these steps to pair:
1. Start with the Receiver Collar off your pet and powered off.
2. Press and hold the On/Off Button until the Green LED shuts off. When the Green
LED shuts off, release the On/Off Button and the Receiver Collar LED will flash
green.
3. Place the Handheld Remote into pairing mode by pressing the Vibration Down
Button (–) until the Digital Display shows "P".
4. Press the Tone and Vibration Buttons simultaneously (the Orange LED should be lit)
until the Receiver Collar flashes the Green LED 5 times, indicating it has learned the
Handheld Remote ID.
5. Change the level to 1 Low by pressing the Vibration Up Button (+) on the Handheld Remote and then press
the Tone Button. The Receiver Collar will emit a tone, verifying that it is paired with the Handheld Remote.
6. If the Receiver Collar does not respond, please contact the Customer Care Centre.

Test the Remote Trainer

We recommend you experience first-hand how the Remote Trainer functions. Always begin at the lowest
level and increase the intensity up to your personal comfort level.
1. Place your fingers on both Vibration Points of the Receiver Collar.
2. Hold the Handheld Remote approximately 0.6 metres from the Receiver Collar and press the
Vibration Up Button (+) to show Level 1 on the Digital Display. Press the Vibration Button (blue). At this
level you may not feel the Vibration Stimulation.
Note: An automatic safety time-out will be triggered if any Vibration Button is held for more than 10
seconds. Once released, the Vibration Button resets to normal functionality.
3. Increase the intensity until the sensation begins to feel uncomfortable.

TRAINING GUIDE

www.petsafe.net 15