Prepare The Receiver Collar; To Insert And Remove The Batteries - Petsafe VT-100 Manual De Funcionamiento

STEP 2

Prepare the Receiver Collar

To Insert and Remove the Batteries

1. Remove the screws with a small Phillips
screwdriver, applying adequate pressure
for the screwdriver head to fit snugly into
the screw. Remove the Battery Cover (2A).
2. Install one (1), 3-volt (CR2) battery as
shown (2B). Place the Battery Cover
back into the Receiver Collar. Note:
Be sure the gasket on the inside rim of
the Battery Cover is intact each time
you replace it.
3. Reinstall the screws. Do not over-tighten
the screws.
Replacement batteries can be found at many
retailers. Contact the Customer Care Centre or visit our website at www.petsafe.net for a list of common retailers.
Risk of explosion if battery is replaced by an incorrect type. Do not short circuit, mix old
and new batteries, dispose of in fire, or expose to water. When batteries are stored or
disposed, they must be protected from shorting. Dispose of used batteries properly.
To turn the Receiver Collar On
1. Press and hold the On/Off Button until the unit beeps and the Green LED light comes on. (This takes
approximately one second.)
2. Release the On/Off Button. The Green LED will flash once every 5 seconds, indicating the Receiver
Collar is on and ready to receive a signal from the Handheld Remote.
To turn the Receiver Collar Off
1. Press and hold the On/Off Button until the unit beeps and the LED light shuts off. (This takes
approximately 3 seconds.)
2. Release the On/Off Button. Note: To extend the life of the batteries, turn the Receiver Collar off when
it is not in use.
Important: If the Receiver Collar is left on continuously, the maximum battery life will be two weeks.
12
2A
2B
www.petsafe.net