Problems And Causes - Active LionCut Manual De Empleo Y Mantenimiento

18. PROBLEMS AND CAUSES

Unit
PRUNER
(*):If the problem persists consult your dealer and or the Service Centre nearest you.
Problem
The pruner stops
during the job.
The pruner doesn't
work.
The pruner has a low
cutting force or has a
bad cut.
The pruner will
overheat.
The battery does not
last long.
Tel. +39 0375 91742 Fax +39 0375 91684
Probable cause
Advice of error (see
display). See the relative
paragraph.
The pruner has not been
correctly connected to its
power unit.
The blade of the pruner
is located in a different
point from the closure.
The battery is down.
The cutting blade is very
worn or indented.
The fix cutting blade is
very worn.
The cutting blade is very
worn or indented.
The fix cutting blade is
very worn.
The cutting blade is very
worn or indented.
The fix cutting blade is
very worn.
The battery charger
doesn't work.
Active S.r.l.
Via Delmoncello, 12 – 26037 San Giovanni in Croce (Cr) – ITALY
Possible solution (*)
The pruner must be delivered
to an Authorised Reparation
Centre for check.
Check the correct connection
of the pruner with the power
unit.
Switch on following the
standard procedure.
Verify that the batteries are
charged.
Always keep the cutting blade
well sharped.
Check and sharpen or change
if it's necessary.
Always keep the cutting blade
well sharped.
Check and sharpen or change
if it's necessary.
Always keep the cutting blade
well sharped.
Check and sharpen or change
if it's necessary.
Check the state of the battery
charge.
www.active-srl.com
46