Warnings And Alarms - Active LionCut Manual De Empleo Y Mantenimiento

10. WARNINGS AND ALARMS

Ref. Fig. A, Fig. D
In every single case necessary to inform the user, the machine does it with the combination of the
display (13), led "alarm" (12) and sound warning.
There are warnings and alarms.
The advices are in relation to situations that the user must know, but they do not prejudice the
functioning of the machine that can be used. The causes of the advise must however be solved quickly.
The alarms are in relation to situations that do not allow the machine of working. In these cases the
control system blocks the machine. The alarms are reset pressing the button 8 in position "II". After
having switched on the machine again, if the alarms it presents again, it's necessary to go in an
authorised centre of reparation for a check.
Advices:
Battery almost down 10% (D22):

During the usage when the battery goes down below 10% of the remaining charge.
End the job and recharge the battery.
Battery almost down 5% (D23):

During the usage when the battery goes down below 5% of the remaining charge.
End quickly the job and recharge the battery.
Watch battery down (D24):

In order not to lose date and hour, to substitute the battery of the watch applying to an
authorised reparation centre.
Executing the programmed maintenance (D25):

The machine must be brought to an authorised reparation centre to execute the programmed
maintenance. The advice is shown at every switch on and up to the maintenance will be
effected. The machine works correctly. It's possible to use the machine for some days but
within a short period of time the voucher must be executed. (see the relative paragraph).
Self Switch off within 60 seconds (D26):

The machine has been unused for 9 minutes. One is missing from the self switch off. The
seconds viewed on the display are the ones missing from the automatic switch off.
General Advice (D27):

The presence of the symbol for general advice means that one advice is in force.
Battery in charge (D28):

The advice means that the battery charger is connected. The battery is loading.
Battery completely charged (D29):

The advice means that the charge of the battery is completed. Disconnect the connector of the
charger.
Alarms:
Battery completely down (D30):

The battery is down. The machine can't work anymore. To charge the battery.
Blade position error (D31):

The reading of the blade's position is not correct. To re start and, if the problems represents
apply to an authorised reparation centre.
High current error (D32):

The current registered by the electronic control is too high. Start again and if the problem
appear again apply to an authorised reparation centre.
Communication error (cable) (D33:

The communication between the body and the power unit is stopped (ex: cable detached or
bad connected). Switch on again and if the problem appears again apply to an authorised
reparation centre
Memory Error (D34):

Active S.r.l.
Via Delmoncello, 12 – 26037 San Giovanni in Croce (Cr) – ITALY
Tel. +39 0375 91742 Fax +39 0375 91684 www.active-srl.com
40