Active LionCut Manual De Empleo Y Mantenimiento página 34

5. COMPONENTS
Ref. fig. A
A Body
B Complete Backpack
C Scabbard
D Electronic Unit
E Battery
F Pruner Cable
G Battery Charger
1 Trigger
2 Fixed blade
3 Movable blade
4 Male connector for body
5 Female connector for cable
6 Male connector for cable
7 Female connector for power unit
8 Switch I-II
IMPORTANT
Each machine is equipped with a named plate reporting the manufacturer's name, the model, the year of
manufacturing, the CE mark and the serial number which must be always communicated in case of
technical assistance.
6. PREPARATION
Ref. fig. A
To Read the manual instruction carefully in all its parts
To Take out from the plastic handbag H, the body A, the backpack B with scabbard C, the cable F, the
arm belt L, the sharpening stone J.
To Charge the battery completely before using the machine for the first time (see the relative paragraph)
To be sure that all components of the machine are whole.
To connect the cable to the body through the connectors 5 and 4. To verify that the Electronic Unit D is
switched off (display 13 switched off). To connect the cable to the Electronic Unit in the Backpack
through the connectors 6 and 7.
To screw the connectors thoroughly, without forcing and paying attention to the correct thread alignment
of the connectors. Remove the cap N from the blades. To wear the backpack connecting and tightening
carefully all the belts included the ones of the scabbard.
To fix the cable to the arm using the arm belt. To verify that the blades are correctly sharped. To bring
with you the sharpening stone which will be useful during the pruning.
Now the machine is ready to be switched on and used.
7. STARTING
Ref. fig. A, fig. B
To start the cutting cycle, press the button 8 on the position I. The display 13 lights up and, after ACTIVE
Logo, on the display it appears the written D1. Following therefore the instructions pressing and holding
down the trigger 1 of the body up to the slow complete zero resetting of the blade 3 is completed. To
release the trigger. The written on the despay changes and becomes D2. The position of the blade now is
correct and it's possible to start the cutting cycle. During the standard cutting cycle the written on the
H Plastic Handbag
I Sharpening Stone
J Detergent for blades
K Key for blade
L Arm belt for cable
M Instruction Manual
N Plastic blade cap
9 Female connector for battery charger
10 Led green ON
11 Function button F
12 Led red ALARM
13 Graphic Display
14 Male connector for battery charger
15 Current-plug for battery charger
Active S.r.l.
Via Delmoncello, 12 – 26037 San Giovanni in Croce (Cr) – ITALY
Tel. +39 0375 91742 Fax +39 0375 91684 www.active-srl.com
34