Active LionCut Manual De Empleo Y Mantenimiento página 42

The electric net must be equipped with the grounding.

IMPORTANT: to maintain the battery in excellent condition and to avoid to damage it in permanent way,
you must pay attention to the following precautions:
Before to put down for long time the machine after the pruning campaign a complete recharge

of the battery must be effected.
This charge must be repeated every 4 MONTHS at least and however any time for a maximum

of 4 MONTHS that the machine is not used.
IMPORTANT: In case these precautions are not practiced the autonomy and efficiency of the batteries
are reduced significantly and there are no reason of warranty.
Even if it's possible to charge the battery when it's not completely charged we advice for a more suitable
life of the battery to work until the battery is completely down at least once every 1÷2 months during the
pruning campaign.
12. OBSERVATIONS, WARNINGS AND ADVICES FOR THE USAGE
Ref. Fig. A
For the usage of the machine, it's important to keep in mind all observations, warnings and advices for
the usage mentioned in this manual instruction and apply them every day. In this way the machine will
be always in excellent condition and it will give excellent results of cut.
While valuating the wood to cut keep always in mind the field of application of the present

machine as described in this manual.
The breakdown caused by a bad or inadequate usage and out of the field of applications

indicated and described in the present manual are not covered by the warranty.
The warranty covers defect of production or of naissance in the components of the machine.

While valuating the wood to cut, you have to keep in mind that not all types of wood present

the same resistance to the cut, in fact every wood requires a different effort. This means the
necessity to modify the diameter of the type of cut according to the different type of wood.
The maximum diameter of the cut is of around 40 mm. It deals of approximate and maximum
data. For the type of wood with high resistance to the cut like orange or olive trees the
maximum diameter reduces compared to the standard indications.
We advice do reset the half and progressive cut in case you believe it's not necessary to use it

in relation to your exigencies of work. If you decide to leave them inserted however the
machine will work always in a correct way.
The function of repetition cut has the aim to control and limit some excessive effort of the

machine. If the function of cut in repetition is on with a high frequency, it means that the effort
of the cut is always very near to the maximum level of the machine. Therefore it means that
the you are cutting wood too strong or of big dimensions with blades no correctly sharpened in
bad conditions. To verify the blades and the wood you are cutting before to start again your
job considering the field of application.
The battery of the machine deliver tension when the power unit is switched on. Switch off the

machine when you do not use it without waiting for its self turning off. In this way the
autonomy of the battery increases.
Switch off the machine always with closed blades, except when you have to sharpen the blade.

The electronic control of the machine memorizes the cut made, registering for each cut the

electric data useful to have a record important in case of technical service.
To insist repeatedly on the same point of cut with excessive effort it damages the pruner. You

can cause severe damages which compromise the correct working of the pruner. This type of
damages are not covered by the warranty.
The pruner has been designed exclusively for pruning. Using it for different type of materials

different from wood can cause damages to the pruner and to its blades. This type of damages
are not covered by warranty.
Be advised not to change the body and the power unit with different machines. The body and

the power unit of a machine are designed to work together.
Active S.r.l.
Via Delmoncello, 12 – 26037 San Giovanni in Croce (Cr) – ITALY
Tel. +39 0375 91742 Fax +39 0375 91684 www.active-srl.com
42