TRAPP TR 500 Manual De Instrucciones página 68

After that, make sure all machine screws
and nuts are properly tightened (see table
"Torque Specifications").
Pay attention to the front wheels of the
tractor. When the shredder is upright from
the ground and the wheels seem very light,
place a bracket on the front of the tractor
to balance the weight.
Image merely illustrative
Cardan assembly
3
The TR 500T can be ease transported to the

workplace, where you want to deposit the shredded
material, being suspended by the hydraulic system
of the tractor.
The assembly of the shredder in the tractor must

be carried out by the structure of 3 fixing points of
the equipment for a safety work, according to the
indication of the image on the side.
Fixation points
Image merely illustrative
68
Check the indication of load capacity when

suspending the TR 500T in the hydraulic system
of the tractor, check the weight of the machine on
page 60.
To avoid cardan axle overload, a minimum wear

of 1/3 of its length is necessary. The axle shall be
secured according to manufacturer standards.
The recommended inclination of the cardan shaft

in work is a maximum of 15°, adjust the angle of
inclination by regulating the hydraulic system of the
tractor. If the model of the tractor allows and the
angle is compatible, keep the TR 500T supported
on the ground during work to obtain the best access
to the feeding funnel. If the height of the machine
is uncomfortable to feed the due to the inclination,
place the tractor on a terrain with elevations to
facilitate access to the feeding funnel of the TR 500T
and keep the equipment based on the ground.
Note:
When suspending the TR 500T with the

hydraulic system of the tractor, check
the maximum permitted inclination
of the cardan shaft mounted on the
machine and on the tractor PTO.
Exceeding the inclination can damage
the equipment and cause excessive
vibration in the shredder in operation.
To carry out maneuvers with the

TR 500T mounted on the tractor,
disconnect the cardan shaft from
the equipment. When placing the
equipment in the ideal place of work,
reassemble the cardan shaft and check
the inclination of the cardan shaft.
Before mounting the cardan shaft follow the
recommendations below:
Remove the cardan shaft from the packaging and

separate the male and female connector.
To obtain the measurement to cut the cardan shaft,

assemble the equipment on the 3 tractor tips, align
the tractor PTO shafts and the PTO shaft of the
machine and check the distance measurement
between the shaft ends.
www.trapp.com.br