Replacing The Door Panel; Connecting The Refrigerator To Dc Voltage - Dometic CRE0050 Instrucciones De Montaje

CRE
7.6

Replacing the door panel

A
NOTICE! Risk of damage!
The door panel must be replaced only when the refrigerator is upright.
The decorative trim has the following measurements (see fig. 0, page 8):
Model
CRE0050
CRE0065
CRE0080
Removing and installing the decorative trim
➤ Proceed as shown (fig. a, page 8 to fig. c, page 10) to remove the decorative
trim.
➤ Proceed in reverse sequence to install the decorative trim.
7.7

Connecting the refrigerator to DC voltage

A
NOTICE!
• To avoid voltage drops and loss of performance, keep the
connection cable as short as possible.
Avoid additional switches, plugs or power strips.
• Disconnect the cooling device and other electric consumers from
the battery before you connect the battery to a quick charging
device. Overvoltage can damage the electronics of the device.
The refrigerator can be operated with DC voltage supply (12/24 Vg).
For safety reasons, the refrigerator is equipped with an electronic system to prevent
the polarity being reversed. This protects the refrigerator against reversed polarity
when connecting to a battery and against short circuiting.
To protect the battery, the refrigerator switches off automatically if the voltage is
insufficient (see table below).
Cut-off voltage
Cut-in voltage
EN
Installing and connecting the refrigerator
A
350 ± 0.5 mm
419 ± 0.5 mm
445 ± 0.5 mm
B
474 ± 0.5 mm
468 ± 0.5 mm
582 ± 0.5 mm
12 V
10.4 V
11.7 V
C
0.5 mm
24 V
22.8 V
24.2 V
23