Ki Mobility Little Wave FLIP XP Manual De Instrucciones Y Garantía página 43

V. SET UP & USE OF YOUR WHEELCHAIR
V. Axle Arm
3. Adjusting Axle Spacing
a. Loosen axle sleeve nut (Fig. 51:B) using 24mm wrench.
b. Thread axle sleeve in or out of axle tube to achieve desired wheel spacing.
c. Retighten axle sleeve nuts.
d. Ensure both sides of the chair have the same axle spacing.
e. Retighten axle sleeve nuts.
Fig. 51
DANGER: Adjusting the axle position too far forward can result in a chair that may tip over
backward resulting in a fall or loss of control that could cause severe injury or death.
WARNING: Increasing the seat to back angle will change the center of gravity of the wheelchair.
Make sure your axle position is adjusted properly in order to maintain constant stability of the
wheelchair. Reference instruction for axle arm position in Section V: Axle Arm.
C
41
B
A