Swing Away Hangers With 4-Way Latch - Ki Mobility Little Wave FLIP XP Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
H. Swing Away Hangers with 4-Way Latch
1. Installation
a. Place swing away pivot saddle into the receiver on front frame
tube (Fig. 13:A).
b. Rotate the footrest so that it aligns with the frame and locks into
place in the latch block (Fig. 13:B).
2. Swinging the Footrest Away
a. Push or pull on release latch.
b. Rotate footrest outward or inward as desired.
3. Removal
a. To remove footrest, push or pull release latch.
b. Lift the footrest straight upward to remove. You may also swing
the footrest inward or outward before lifting it off.
4. Rotating (Fig. 14)
The 4-way latch has eight possible configurations, four with the curve
of the lever facing outward and four with the curve of the lever facing inward. See Fig. 15 for
possible configurations.
a. To rotate the 4-way latch, remove the screw using a 3mm Allen wrench while the hanger is
still on the chair (spring must be engaged to remove and reinsert screw and keeping the
hanger on the chair keeps the spring engaged). Ensure nut does not fall out.
b. Rotate the 4-way latch to desired orientation and rein-
sert screw with 3mm Allen wrench. Ensure that nut
stays in position while tightening the screw. Do not
overtighten screw or mechanism will bind.
NOTE: To reverse the 4-way latch, the same screw is
removed, but the hanger has to be removed from the latch
block. Once removed, slide the latch off, flip over and
reinstall. Ensure spring is engaged, by pushing and holding the latch button in, and nut stays in
position while reinstalling the screw.
NOTE: In-line position is not achievable with the Pro ELR Footrest option.
NOTE: On the Flip wheelchair, using the 4-way latch in the vertical in-line position allows the chair
to be folded without removing hangers.
Fig. 15
Lever Facing
Outward
Eight Possible Configurations
Standard Position
23
A
Fig. 14
Screw
Lever Facing
Inward
Fig. 13
B
Nut