Ki Mobility Little Wave FLIP XP Manual De Instrucciones Y Garantía página 33

V. SET UP & USE OF YOUR WHEELCHAIR
O. Backrest
3. Adjusting Height
a. If chair is equipped with a height adjustable backrest,
remove both screws (Fig. 33:A) of the telescoping back-
rest tubes using a 10mm wrench.
b. Move upper tubes up or down to set height as desired.
c. Replace screws and nuts to set height.
4. Push Handle Angle Adjustment
a. If chair is equipped with a height adjustable backrest,
push buttons of locking hinges (Fig. 33:B). Both buttons
must be pressed simultaneously to adjust angle.
b. While holding buttons down, rotate push handle to
desired position.
c. Release buttons when desired angle is achieved.
d. Verify that hinge is locked by pulling upwards on push
handles.
5. Removable Stroller Handle
a. Depress buttons (Fig. 34:A) on both sides of chair
toward lower end of stroller tubes to disengage lock-
ing tabs.
b. Pull handle out of receivers to remove or push stroller
handle into receivers to install. For best results, insert
both sides at the same time.
c. Verify snap buttons are engaged in receivers.
DANGER: Do not attempt to lift or tilt the wheelchair by holding the center strut that joins the
Adjustment Height Back push handles (Fig. 33:C) or the center strut that joins Removable Stroller
Handle push handles (Fig. 34:B). These struts may break resulting in a fall or loss of control and
may cause serious injury or death.
6. Dynamic Back
a. See instructions for this back provided separately with chair.
A
31
C
A
B
B
Fig. 33
Fig. 34