Volume Control; Description Parent Unit / Receiver V- Vibration Alarm - Reer 3004 MIDI Manual Del Usuario

ON-/OFF-BUTTON:
The Sender unit's ON-/OFF-BUTTON is the main power switch and turns on the entire unit. The Sender unit's ON-/OFF-BUTTON is the main power switch and turns on the entire unit. The Sender unit's ON-/OFF-BUTTON is the main power switch and turns on the entire unit.
LED DISPLAY CHANNEL A/B: LED DISPLAY CHANNEL A/B:
The unit can be operated on two different channels in order to avoid interferences. These channels
are individually adjustable. Hold down the „M"-button until channel ‚A' or ‚B' starts flashing. Now
select the select the select the - or - or - or option to select a channel. Push "M"-button again to confirm. SENDER and option to select a channel. Push "M"-button again to confirm. SENDER and option to select a channel. Push "M"-button again to confirm. SENDER and
RECEIVER must operate on the same channel.
LED DISPLAY POWER / STANDBY:
A green LED display indicates that the power has been turned ON. When the baby does not make
any sound, the unit is in STAND BY MODE and a green LED light is flashing. Red LED light indicates
low batteries.

VOLUME CONTROL:

Now select the volume level via the Now select the volume level via the Now select the volume level via the
The volume changes in accordance with the LED display from left (low) to right
(high). The speaker can be turned off by disabling all volume LED indicators.
LED DISPLAY SIGNAL STRENGTH:
The numbers of LEDs indicate the strength of the signal being received. They
are independent from the volume level and are a visual control of the signal
strength. This feature is useful when you want to avoid disturbing other
people, e.g. vacuuming.
VIBRATIONSALAVIBRATION ALARM (OPTIONAL):
The vibration alarm operates in impulses and is independent from the
volume level. It is active even if the volume has been disabled. The
VIBRATION ALARM is located inside the battery compartment and can
be enabled/ disabled with a pen, paper clip or needle.
page 15
3004.indb 15
parent unit
(receiver)
- or - or - or -button on the RECEIVER unit. -button on the RECEIVER unit. -button on the RECEIVER unit.
BUTTONS:
01. Antenna
02. Channel A/B LED
03. Range Control Display
04. Volume-LEDs
05. Microphone
06. ON/OFF - button
07. POWER/STANDBY battery check light
08. Strap connection
09. Button "UP"
10. „M"-button
11. Button "DOWN"
12. Plug
13. Battery compartment
14. Reset-button
LED DISPLAY AND ACOUSTIC
ALARM WHEN BATTERY IS LOW:
A red LED display light accompanied by
an acoustic sound indicates a low battery
Please recharge the batteries by plugging
the adapter into an outlet. The BABYPHONE
is operational during the recharging process.
The included batteries can be recharged
up to 500 times which is equivalent to 1.5
years of average use.
TIP:
If the RECEIVER unit is beyond the
SENDER unit's range, a green LED light,
accompanied by an acoustic signal, will
start flashing.
RECHARGING BATTERIES WITHIN
THE UNIT:
Insert 3 rechargeable AAA batteries
into the battery compartment and
connect the adapter to a wall outlet.
NOTE:
Only the included batteries are rechargeable
in the Babyfone unit itself!
30.04.2008 17:46:23