Digital Coding; Maintenance And Repair - Reer 3004 MIDI Manual Del Usuario

SENDER
SENDER
ON
OFF 1 2 3
ON
OFF 1 2 3
ON
1 2 3
OFF
ON
1 2 3
OFF
DIGITAL CODING SYSTEM :
The DIP-switch is equipped with 8 combinations in order to avoid interferences with other control
units which operate on the same frequency.
How to program the combination code:
1. Turn the SENDER and RECEIVER unit off and position the units side by side.
2. Open the battery compartment and remove all batteries.
3. Program a new combination code by adjusting the setting with the tip of a pencil. Make sure the
SENDER and RECEIVER code are IDENTICAL.
4. Turn both units back on and perform an acoustic test.
5. The code has been programmed successfully if the SENDER unit is transmitting sounds to the
RECEIVER unit. If sounds cannot be heard, check for the code settings on both units.

MAINTENANCE AND REPAIR :

Avoid operating the units in extreme humidity, in extreme heat or under direct sunlight.
Clean the units with a damp cloth, no cleaning agents please.
Do not expose the unit to any water.
Remove all batteries and the adapter if the unit is not in use for an extended period of time.
This product does not contain any parts that have to be serviced by the consumer.
Please to NOT disassemble the unit yourself if it requires maintenance or repair. Simply return to the
manufacturer.
page 17
3004.indb 17
RECEIVER ON/OFF-EXAMPLE
EMPFÄNGER EIN/AUS MUSTER
ON
1 2
OFF OFF OFF
OFF 1 2 3
ON
1 2
ON OFF OFF
OFF 1 2 3
ON
1 2
ON ON OFF
1 2 3
OFF
ON
1 2
ON ON ON
1 2 3
OFF
SENDER RECEIVER
SENDER EMPFÄNGER
ON ON
3
OFF 1 2 3 OFF 1
ON ON
3
OFF 1 2 3 OFF 1
ON ON
3
OFF 1 2 3 OFF 1
ON ON
3
OFF 1 2 3 OFF 1
ON/OFF-EXAMPLE
EIN/AUS MUSTER
1 2 3
OFF ON OFF
2 3
1 2 3
ON OFF ON
2 3
1 2 3
OFF OFF ON
2 3
1 2 3
OFF ON ON
2 3
30.04.2008 17:46:24