Filling The Front Brake Reservoir With Brake Fluid; Adjusting The Position Of The Rear Brake Pedal; Checking The Travel Of The Rear Brake Pedal - SHERCO SE 250i Manual De Propietario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Filling THe FrOnT braKe reservOir WiTH braKe FlUid

2
3

adjUsTing THe POsiTiOn OF THe rear braKe Pedal

1
2

CHeCKing THe Travel OF THe rear braKe Pedal

1
h
1
- The hydraulic fluid is highly corrosive.
- It can be dangerous to the skin.
- Read the recommendations on the container.
a
- Remove the two screws
Remove the cover
Fill the reservoir with brake fluid to the correct
level
a
Level of brake fluid below
the top of the reservoir.
Minerva brake fluid
- Reinstall the membrane, the cover and the
screws.
The position of the brake pedal can be adjusted as
follows: loosen the lock nut
the screw
Tighten the lock nut when the pedal is properly
located.
Brake pedal lock nut
Check the pedal travel (
- Remove the spring
- Operate the pedal several times
Rear brake pedal travel
- Replace the spring
a
If the travel does not meet the specification, refer
to the rear brake travel adjustment. (
aTTenTiOn
1
and the membrane
2
.
1
to obtain the desired position.
2
p.111)
1
1
.
.
3
5mm
loosen or tighten
M6 10Nm
3mm ≥
≥5mm
a
p.112)
111
Tabla de contenido
loading

Este manual también es adecuado para:

Se 300i

Tabla de contenido