Replacing Parts; Replacement Of The Burner Nozzle - Angelo Po 0G1FR3GD Manual De Uso

INSTRUCTIONS AND WARNINGS FOR REPLACING PARTS
Before carrying out any replacement procedure, ac-
tivate all the safety devices provided and decide
whether staff at work and those in the vicinity
should be informed. In particular, turn off the gas
supply tap, cut off the electricity supply using the
master switch and prevent access to all devices
that might cause unexpected health and safety haz-
ards if turned on. If worn parts have to be replaced,

REPLACEMENT OF THE BURNER NOZZLE

To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Open the door (A).
3 - Unscrew the nozzle (B) and replace it with
the one suitable for the type of gas in use
(see table at back of manual).
4 - Close the door (A).
IT
GB
DE
REPLACING THE BURNER AIR BUSHING
FR
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Open the door (A).
ES
3 - Undo the screw (B).
4 - Extract the bushing (C) and replace it with the one suita-
ble for the type of gas in use (see table at back of manual).
5 - Adjust the position of the bushing (C) (see pag.23).
6 - Tighten the screw (B).
7 - Close the door (A).
English

REPLACING PARTS

- 26 -
use original spare parts only. The manufacturer de-
clines all responsibly for injury or damage to com-
ponents due to the use of non original parts, or
extraordinary work on the appliance which may
modify the safety requirements without the manu-
facturer's authorisation. When ordering compo-
nents, follow the instructions provided in the parts
catalogue.
A
A
9
B
IDM-39603311700.tif
C B
IDM-39603314700.tif