Starting And Stopping The Cooking Cycle; Filtering Oil - Angelo Po 0G1FR3GD Manual De Uso

To start and stop the appliance, proceed as follows.
Starting
1 - Light the burners (see page 11)
2 - Press key (A) and then key (B) to activate the
oil "melting" procedure.
When the
reached the beeper sounds.
3 - Press key (C) to deactivate the "melting" func-
tion.
The temperature is maintained at 100°C until
cooking starts.
4 - Press key (D) to activate the temperature input
mode.
5 - Press keys (C-D) to set the cooking tempera-
ture.
The data set on the control panel are retained in
the memory until the gas supply is turned
off.
6 - Press key (A) to terminate the tempera-
ture maintenance function.
7 - Press button (B) to start the cooking cycle.
Lights (E-F) flash while the oil is heat-
ing to the temperature of use, and then
remain constantly on.
8 - To display the temperature set during cooking,
press key (D).
IT IT
GB GB
To carry out this operation, proceed as follows.
DE DE
Important
Before proceeding, allow the appliance to
FR FR
cool for 10÷15 min., so that the oil reaches
a temperature between 50÷120°C.
ES
ES
1 - Open the hatch (A).
2 - Fit the extension (B) onto the tap (C).
3 - Place the container (D) and the filter (E), both
available as optionals, underneath the exten-
sion (B).
4 - Turn on the tap (C) to empty the well.
5 - Turn off the tap (C) on completion of the opera-
tion
.
English

STARTING AND STOPPING THE COOKING CYCLE

preheating temperature

FILTERING OIL

G
is
D
Stopping
1 - Press key (B) to stop the cooking cycle.
Important
If the electricity supply is cut off for less
than 20-40 seconds, the cooking cycle re-
starts automatically.
If the blackout lasts more than 40 seconds,
press key (B) to restart the cooking cycle.
A
B
- 12 -
B E
C A F
IDM-39603615600.tif
C
IDM-39603310800.tif
C
E
D