The Machine Does Not Clean Properly; The Squeegee Does Not Dry Perfectly; Excessive Foam Production; Programmed Maintenance - Floorpul amber 66 24v Manual De Uso Y Mantenimiento

GB
outlet by taking off the two screws which fix it to
the tank. Clean the inside filtrating part of the fit-
ting from eventual dirt. Pour some water into the
tank and clean it. Reassemble the fitting onto the
solution tank.
If the problem persists, please contact the authorized
technical assistance.

THE MACHINE DOES NOT CLEAN PROPERLY

1. The brushes do not have the suitable bristle di-
mension: contact the authorized technical assistance.

PROGRAMMED MAINTENANCE

INTERVENTION
RECOVERY TANK CLEANING
SUCTION FILTER CLEANING
SOLUTION TANK FILTER CLEANING
BRUSHES CLEANING
BRUSHES DISASSEMBLY AND CLEANING
SQUEEGEE CLEANING
FRONT SQUEEGEE RUBBER REPLACEMENT
REAR SQUEEGEE RUBBER REPLACEMENT
SPLASH GUARD RUBBER REPLACEMENT
CHECK SQUEEGEE ADJUSTMENT
SQUEEGEE HOSE CLEANING
SOLUTION TANK CLEANING
CHECK BATTERIES ELECTROLYTE
CHECK OF THE BRAKE
CHECK OF THE HYDRAULIC SYSTEM
TRACTION MOTOR CHECK
BRUSHES MOTOR CHECK
SUCTION MOTOR CHECK
CHECK BRUSHES BASE GROUP
SCREW TIGHTENING
* The hours refer to the ones indicated on the display (see under paragraph "HOUR METER").
2. The brushes have got worn bristles. Check the
brushes wear condition and eventually replace them
(the brushes have to be replaced when the bristles
have reached a height of about 15mm).
To replace brushes, see instructions at paragraph
"BRUSHES DISASSEMBLY" and "BRUSHES ASSEMBLY".
3. The detergent solution is insufficient: open more
the solution valve.
4. Check that the liquid detergent is in the recom-
mended percentage.
5. Increase the brushes base pressure (see at para-
graph "ADJUSTMENT OF THE BRUSHES PRESSURE").
Contact the authorized technical assistance for ad-
vice.

THE SQUEEGEE DOES NOT DRY PERFECTLY

1. Check that the squeegee rubbers are clean.
2. Check the adjustment of the height and the in-
clination of the squeegee (see section "ADJUSTMENT
OF THE SQUEEGEE" in "BEFORE USE").
3. Check that the suction hose is correctly inserted
in the proper seat on the recovery tank.
DAILY
29
4. Clean the suction filter.
5. Replace the rubbers if worn out.
6. Check that the suction motor switch is on.

EXCESSIVE FOAM PRODUCTION

Check that low foam detergent has been used. Even-
tually add small quantities of anti foam liquid into
the recovery tank.
Please be aware that a bigger quantity of foam is
produced when the floor is not very dirty. In this ca-
se please dilute detergent solution.
20 HOURS *
•
•
•
•
•
•
•
•
•
•
•
200 HOURS * 1000 HOURS *
•
•
•
•
•
•
•
•
•
GB