Adjustment Of The Squeegee; Splash Guard Assembly; Brushes Assembly - Floorpul amber 66 24v Manual De Uso Y Mantenimiento

GB

ADJUSTMENT OF THE SQUEEGEE

In order to have a perfect drying result through the
squeegee, the rear rubber must have the lower bend-
ing uniformly adjusted in all its length. For the ad-
justment, it is necessary to put oneself in working
condition and therefore the suction motor has to be
switched on and the brushes have to function to-
gether with the detergent solution.
The lower part of the rubber is too much bent
Take off the pressure rotating the wing nut (6) coun-
terclockwise.
The lower part of the rubber is not much bent
Increase the pressure rotating the wing nut (6)
clockwise.
The bending is not uniform
Adjust the squeegee inclination rotating counter-
clockwise the wing nut (7) to increase the bending in
the central part, or clockwise to increase the bending
on the extremities.
Height adjustment
Once that the pressure and inclination of the squee-
gee has been adjusted, it is necessary to fix this op-
timum condition making touch slightly the wheels
onto the floor. Rotate clockwise the registers (8) to
lower the wheels or counterclockwise to raise them.
Both wheels must be adjusted in the same measure.
ATTENTION:
Every type of floor requires a specific adjustment.
For example, concrete floors (where the friction re-
sults to be high) need little pressure, while smooth
floors (ceramics) need higher pressure.
If the cleaning operations are made always on the
same type of floor, the adjustment can change only
in function of the rubber wear.

SPLASH GUARD ASSEMBLY

The two splash guards have to be assembled onto the
brushes base group. Insert the metal strips inside the
suitable slots present on the rubber. Place the round
hole at the flat extremity of the strip onto the screw
(1) placed in the front part of the brushes base
group. Secure the strips through the nut blocking it.
Block the coupling levers (2) in the rear part of the
brushes base group to the rings placed at the ex-
tremity of the metal strips still free. Please act as
above for both splash guard rubbers, paying atten-
tion to reduce to the minimum the gap between the
two rubbers in the front part of the brushes base
group.
With brushes assembled, the splash guard must
slightly touch the floor.

BRUSHES ASSEMBLY

The machines which have the brushes base lifting
with the manual hydraulic pump:
1. Take off the electric supply by turning the key (9)
counterclockwise.
2. Pull upwards the small lever for the valve control
(1), to activate the pump.
3. Acting repeatedly onto the lever (2) lift the
brushes base.
23
The machines which have the electrical brushes base
lifting:
1. Switch on the machine by turning the key (9)
clockwise.
2. Press the push button (7) of up/down brushes
base to lift the brushes.
3. Take off the electric supply by turning the key (9)
counterclockwise.
ATTENTION:
To carry out brushes assembly operations with the
electric supply on, may cause damages to hands.
With the brushes base group in lifted position, insert
the brushes into their plate seat underneath the
brushes base turning them until the three metal but-
tons are properly seated in their slots; rotate ener-
getically the brushes to push the button towards the
coupling spring until they get blocked.
The figure shows the rotating sense for brushes cou-
pling.
For a longer life of the brushes we suggest to invert
daily their position. Whenever brushes were de-
formed we suggest to reassemble them in the same
position, avoiding that the different inclination of
the bristles causes excessive motor overload or trou-
blesome vibrations.
GB