Bosch GCM12SD Instrucciones De Funcionamiento Y Seguridad página 55

2610051827 GCM12SD 08-18.qxp_GCM12SD 9/19/18 2:52 PM Page 55
Auxiliary Fence -
and movement of small cut-off pieces. Remove the saw's sliding fences (see page 34) before attaching the auxiliary fence.
Build auxiliary fence by following pattern below - Material: 3/4" x 1-1/2" wood.
Add 4 holes as dimensioned on pattern -or- Add holes following the next steps:
1) Cut wood to the outside dimensions shown and temporarily attach to saw's stationary fence using two C-clamps.
2) Use 1/4" drill bit to drill first through existing holes in the rear of the stationary fence and then through the wood.
3) Remove wood, countersink the front of the wood and permanently attach to saw's fence with hardware shown below.
OVERALL HEIGHT = 1-1/2"
3-1/16"
Nut (need 4)
Flat Washer (need 4)
Stationary
Fence
Stationary
Fence
Saw Operations
Crown Molding Auxiliary Fence
Using an Auxiliary Fence when cutting Crown molding flat on the table will reduce splintering of your workpiece
7-15/32"
Drill 4 Holes = 5/16" Diameter
Saw Base
Saw Base
OVERALL LENGTH = 26-1/16"
10-19/32"
5/16"
New Auxiliary Fence
5/16" Hole Through
1/2" Countersink
1/4" Flat Head Machine Screw x 2-1/2" Long
(need 4)
Top of Base
and Table
Note: The Stationary Fence is permanently
attached to the Saw Base (do not remove)
New Auxiliary Fence
(assembled to Miter Saw)
Top of Base
and Table
8"
3-1/16"
Board: 3/4" Wide x 1-1/2" High
55