Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4.
Remove the regulator.
5.
Apply pipe sealant tape to the nipple on the standpipe.
6.
Assemble the regulator and orient as shown.
Nipple
NOTE: Arrow indicates flow of air. Make sure it is pointing in the direction of air
flow.
7.
Reapply pipe sealant to gauges and quick connect.
8.
Reassemble outlet pressure gauge and quick connect. Orient gauges to read
correctly. Tighten connect with wrench.
Before you store the air compressor, make sure you do the following:
1.
Review the Maintenance section on the preceding pages and perform
scheduled maintenance as necessary.
Drain water from air tank. See To Drain Tank under Maintenance.
2.
Water will condense in the air tank. If not drained, water will
corrode and weaken the air tank causing a risk of air tank rupture.
3.
Protect the electrical cord and air hose from damage (such as being stepped
on or run over). Wind them loosely around the compressor handle.
4.
Store the air compressor in a clean and dry location.
REPLACEMENT PARTS
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our
service website at www.deltaportercableservicenet.com. You can also order parts
from your nearest PORTER-CABLE Factory Service Center or PORTER-CABLE
Authorized Warranty Service Center. Or, you can call our Customer Care Center at
(888) 848-5175.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For infor-
mation about PORTER-CABLE, its factory service centers or authorized warranty ser-
vice centers, visit our website at www.deltaportercable.com or call our Customer Care
Center at (888) 848-5175. All repairs made by our service centers are fully guaranteed
against defective material and workmanship. We cannot guarantee repairs made or
attempted by others.
You can also write to us for information at PORTER-CABLE, 4825 Highway 45 North,
Jackson, Tennessee 38305 - Attention: Product Service. Be sure to include all of the
information shown on the nameplate of your tool (model number, type, serial number,
etc.).
Regulator
STORAGE
SERVICE
23 - ENG
Regulator
Arrow
Tabla de contenido
