Porter Cable C5512 Manual De Instrucciones página 10

4. Guide the straight end of each retaining
clip through the saddle hole and both
handle holes.
5. Rotate each retaining clip and press
down until it snaps into place over the
handle.
6. If the handle has excessive movement,
it is improperly installed. Check the
following.
A. Are both tabs inside the handle?
B. Does each clip pass through both
the saddle and handle?
TO ASSEMBLE WHEELS
It will be necessary to brace or
support one side of the unit when installing
the wheels because the compressor will have
a tendency to tip.
1. Attach wheels with shoulder bolts and
nuts as shown.
2. Tighten securely. NOTE: The unit will sit
level if the wheels are properly installed.
The wheels and handle do
not provide adequate clearance, stability or
support for pulling the unit up and down
stairs or steps. The unit must be lifted, or
pushed up a ramp.
ASSEMBLE RUBBER FEET
1. Attach rubber feet with the screws,
washers, and nuts provided as shown.
2. Tighten securely.
HOW TO SET UP YOUR UNIT
Location of the Air Compressor
• Locate the air compressor in a clean, dry and well ventilated area.
• The air compressor should be located at least 12" (30.5 cm) away from the
wall or other obstructions that will interfere with the flow of air.
• The air compressor pump and shroud are designed to allow for proper cooling.
Do not place rags or other objects on top of compressor.
INSTALLATION
10- ENG
Handle
Inserted
On Tabs
Retaining
Clip
Handle
Wheel
Nut
Shoulder Bolt
Nut
Flat
Washer
Rubber Foot
Screw