Guarantee - Dometic WAECO SinePower Serie Instrucciones De Montaje

Convertidor de ondas seno
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 44
SinePower
Fault
No output voltage, green
and red LED light, warning
sound, power consuming
device is switched on
The device switches on and
off repeatedly (up to five
times, then the inverter is
switched off)
No output voltage, green
and red LED light
The inverter switches off
when the consumer is
switched on, red Status
LED lights
11

Guarantee

The statutory warranty period applies. If the product is defective, please
contact the manufacturer's branch in your country (see the back of the
instruction manual for the addresses) or your retailer.
For repair and guarantee processing, please include the following docu-
ments when you send in the device:
 A copy of the receipt with purchasing date
 A reason for the claim or description of the fault
EN
Cause
Overheating
Inadequate cable connection
(cross section too small or poor
contact)
Excessive load
Excessive load
Short circuit or electrical wiring
error
Starting current too high
Guarantee
Remedy
Switch off power consuming
devices.
Let the inverter cool down
and ensure better ventilation.
Make certain that the ventila-
tion slots are not covered.
Lower the ambient tempera-
ture.
Use a cable with a larger
cross section and check
contacts.
Switch off the device.
Reduce the load.
Switch on the device.
Switch off the device.
Reduce the load.
Switch on the device.
Switch off the device.
Remove short circuit.
Check electrical wiring.
Switch on the device.
Compare the device power
with the maximum power of
the inverter.
27
Tabla de contenido
loading

Tabla de contenido