Information On Grilling And Combined Operation; Suitable Microwave Tableware; Notes On Operating And Using The Appliance; Initial Operation - Clatronic MWG 789 H Instrucciones De Servicio

Information on Grilling and Combined Operation

• Use heat-resistant tableware only, as radiation heat develops during
grill and combi operation. Plastic containers are not suitable.
• When operating in grill mode only, you may also use metal or
aluminum tableware, but not during normal or combined microwave
operation (see table "Suitable microwave tableware").
• Do not place anything on the top of the enclosure. It will become
hot. Always keep the ventilation slots unblocked.
• Use the grill to place the food closer to the heating element.

Suitable Microwave Tableware

• The ideal material for use in a microwave is transparent and allows
the microwave radiation to heat the food evenly.
• Round/oval dishes and plates are more suitable than rectangular
ones as the food in the corners may overcook.
CAUTION:
Risk of explosion by sealed tableware.
• Open closed containers before cooking or heating.
• Pierce protective plastic foil several times using a fork.
• Microwaves are not able to penetrate metal, so that no metal ves-
sels or plates should be used.
CAUTION:
• Do not use any paper dishes made of recycled material as these
may contain small amounts of metal, which may result in sparks
or fires.
The list below is intended to help you select suitable microwave table-
ware:
Material
Micro-
wave
Heat-resistant glass
yes
vessel
Non-heat-resistant glass
no
vessel
Heat-resistant ceramic
yes
vessel/plate
Plastic vessels suitable
yes
for microwave use
Kitchen roll yes
Supplied pizza plate yes
Metal or aluminium
no
ovenware
Grilling grid no
Aluminium foil and foil
no
containers
*) Microwave + grill or microwave + convection combination modes
**) Except functions A 1 and A 10

Notes on Operating and Using the Appliance

What you should know about microwave operation
• Your device works with microwave radiation, which heats up water
particles in food in a very short time. There is no heat radiation and
therefore hardly any browning.
• Only food should be heated up with this device.
• The device is not suitable for baking in floating fat.
Suitable for
Convec- Combi-
Grill
tion nation *
yes yes yes
no no no
yes yes yes
no no no
no no no
yes yes yes
yes yes no
yes yes no **
yes yes no
• Only 1-2 portions should be heated up at the same time. Otherwise
the microwave will become less efficient.
• Microwaves provide their full energy levels immediately. Pre-heating
is therefore not necessary.
• Never operate the microwave function when the oven is empty.
• The microwave oven does not replace your traditional cooker. It is
used mainly for:
• defrosting deep-frozen food
• rapid warming/heating of food or drinks
• cooking meals.
Notes on Operating the Appliance
• A signal tone sounds when first turning the turning knob.
• Your selection by pressing buttons is confirmed by a signal tone. If
not, you did not press properly.
• If you set a program but do not press the
5 minutes, the setting will be canceled. The display will then show
the current time again.
• When starting a program (except during pre-heating), the remaining
operating time will be displayed. The countdown runs.
• 5 signal tones will indicate the end of the program. After that the
appliance turns off automatically.
• When the door has been opened, the lamp inside the oven will be
on for 10 minutes.

Initial Operation

Installation Instructions
• Install the appliance with the back of the appliance facing the wall.
• Maintain the following safety clearances:
• 10 cm to the back
• 20 cm to both sides
• 30 cm to the top of the microwave.
• In order to avoid interference with the operation of other devices, do
not place your device near other electronic devices.
Preparation
• Use the handle to open the door.
• Remove any accessories from the cooking chamber and unpack.
• If not yet done: Place the drive shaft on the center of the bottom
inside the oven.
• Install the guide ring in the center.
• Position the glass rotating plate in such a way that its lower recess-
es lock onto the center of the drive shaft.
• When using the pizza plate, place it on the grill rack that needs to
be installed on the glass rotating plate.
• Check the device for any visible damage, particularly in the area of
the door. If any damage is found, the machine must not be used.
• Remove any protective foils that may be adhered to the housing.
• Make sure the mains voltage to be used corresponds to the voltage
of the appliance. Check the rating label for specifications.
• Insert the mains plug into a properly installed power socket.
CAUTION:
• Do not remove any installed parts from inside the oven or from
inside the door!
• The mica sheet is also part of the appliance and must not be
removed. It protects the electronic component located behind it
from dirt.
button within
59