Network Settings; Connection Settings - Nokia E Serie Manual De Uso

Automatic redial — Set your device to make a maximum
•
of 10 attempts to connect the call after an unsuccessful call
attempt. To stop automatic redialing, press the end key.
Show call duration
•
the call.
Summary after call
•
the call.
1-touch dialing — Activate 1-touch dialing.
•
Anykey answer — Activate anykey answer.
•
Line in use — This setting (network service) is shown only
•
if the SIM card supports two subscriber numbers, that is,
two phone lines. Select which phone line you want to use
for making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line. If
you select Line 2 and have not subscribed to this network
service, you are not able to make calls. When line 2 is
selected, is displayed in the home screen.
Line change — Prevent line selection (network service),
•
if supported by your SIM card. To change this setting, you
need the PIN2 code.

Network settings

Select Menu Control panel
>
Network.
To select the network mode, select
mode, UMTS, or GSM. In dual mode, the device switches
automatically between networks.
Tip: Selecting UMTS
may increase the demand on battery power and reduce
© 2008 Nokia. All rights reserved.
— Display the length of a call during
— Display the length of a call after
Settings and Phone
>
Network mode
enables faster data transfer, but
the battery life. In regions close to both GSM and UMTS
networks, selecting
jumping between the two networks, which also
increases the demand on battery power.
To select the operator, select
Manual to select from available networks, or
set the device to select the network automatically.
To set the device to indicate when it is used in a microcellular
network (MCN), select

Connection settings

Select Menu
Connection.
Select from the following:
Bluetooth
•
USB — Edit the data cable settings.
•
Destinations
•
Some or all access points may be preset for your device by
your service provider, and you may not be able to create,
edit or remove them.
VPN — Manage the settings for virtual private
•
>
networking.
Packet data
•
and Dual
attached, and enter the default packet switched access
point name if you use your device as a modem for a
computer.
Dual mode
Operator selection
Cell info display
Control panel Settings
> >
— Edit the Bluetooth settings.
— Set up new or edit existing access points.
— Define when packet data network is
Settings
may cause constant
and
Automatic to
> On.
and
151