Connecting The Inverter - Dometic WAECO Perfect Power Serie Instrucciones De Montaje

Fastening and connecting the inverter
Fasten the inverter as follows (fig. 5, page 4):
NOTICE!
A
Before drilling any holes, make sure that no electrical cables or oth-
er parts of the vehicle can be damaged by drilling, sawing and filing.
➤ Clip two holders on the left bar and two on the lower right bar.
You can move the holders as required.
➤ Fasten the inverter by screwing one screw through each hole in the
holder.
8.2

Connecting the inverter

WARNING!
!
The inverter may only be connected by a qualified workshop.
The following information is intended for specialists who are famil-
iar with the guidelines and safety precautions to be applied.
Observe the following safety instructions for the electrical connections:
NOTICE!
A
 Caution – Risk of short circuit!
When working on the vehicle, always disconnect the earth
connection to the supply battery.
 Disconnect the 230 V external power supply to the caravan.
 If you have to feed cables through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
 Do not lay cables which are loose or bent next to electrically
conductive material (metal).
 Fasten the cables securely.
 Do not pull on the cables.
 Do not lay the 230 V mains cable and the 12/24 V DC cable in
the same duct.
 Lay the cables so that they cannot be tripped over or damaged.
32
PerfectPower
EN