Setting / Adjustment; Mains Connection; Chip Extraction; Saw Blade Selection - Mafell KSS 400 Manual De Instrucciones

4

Setting / Adjustment

4.1 Mains connection

Prior to commissioning make sure that the mains
voltage complies with the operating voltage stated on
the machine's rating plate.

4.2 Chip extraction

Connect the machine to a suitable external dust
extractor during all work generating a considerable
amount of dust. The air velocity must be at least 20
m/s (65.6 ft / sec.).
The internal diameter of hose connector 3 (Fig. 1) is
35 mm ( 1 3/8 in.).

4.3 Saw blade selection

Use a sharp tool to obtain a good cut quality and
select a tool from the following list according to
material and application:
For cuts along and across the grain in soft or
hard wood:
- TCT circular saw blade Ø 160 x 1.8 x 20 mm (6 1/4
x 5/64 in. x 20 mm), 24 teeth
For cuts especially along the grain in soft or hard
wood:
- TCT circular saw blade Ø 160 x 1.8 x 20 mm (6 1/4
x 5/64 in. x 20 mm), 16 teeth
For cuts especially across the grain in soft or
hard wood:
- TCT circular saw blade Ø 160 x 1.8 x 20 mm (6 1/4
x 5/64 in. x 20 mm), 32 teeth

4.4 Replacing the saw blade

Danger
Pull the power plug during all
service work.

Press the locking bolt 8 (Fig. 3).

Using the Allen-key 5 (brackets Fig. 2), unfasten
the flange screw 18 (Fig. 1) counter clockwise;
remove the screw as well as the front clamping
flange 12.

Now you can remove the saw blade after
opening the retractable saw guard 13.

The clamping flanges must be free of adhering
parts.

Pay attention to the sense of rotation when
inserting the saw blade.

Afterwards, mount the clamping flange, attach
the flange screw and tighten it by clockwise
turning.

In doing so, keep the locking bolt depressed.
Do not press the locking bolt 8 (Fig.
3) with the machine running! The
machine may get damaged.

4.5 Riving knife / splitter

Danger
Pull the power plug during all
service work.
The riving knife / splitter 15 (Fig. 1) prevents the saw
blade from jamming during longitudinal cutting. The
correct distance to the saw blade is shown in (Fig. 4).

For adjustment, unfasten the screw 16 (Fig. 1)
with the Allen-key supplied with the saw 5 (Fig.
2).

Adjust the riving knife / splitter by shifting it in its
longitudinal slit. Afterwards retighten the screw.
5

Operation

5.1 Initial operation

Personnel entrusted to work with the machine must
be made aware of the operating instructions, calling
particular attention
instructions".

5.2 Switching on and off


Switching on: First press the lock-off button 1
(Fig. 2) and then press the switch trigger 2.

Switching off: To switch off, release the switch
trigger.

5.3 Cutting depth adjustment

The cutting depth is continuously variable between 0
and 49,5 mm (1 15/16 in.).
Proceed as follows:

Release the clamping lever 11 (Fig. 2).

Adjust the cutting depth using the plunge lever
6.
-20-
to the chapter "Safety