Replacing The Tabletop Insert; Accessories; Disposal - Festool KAPEX KS 120 Manual De Instrucciones

9.4

Replacing the tabletop insert

Never work with a worn table insert (20.1),
replace it with a new one.
–To replace the table insert, unscrew the six
screws (20.2).
9.5 Cleaning or replacing window for
laser
The window (21.2) for protecting the laser
can become dirty during operation. It can be
removed for cleaning or replacement.
–Release the screw (21.5) by approx. 2 ro-
tations.
–Press the window at the same time in the
directions (21.3) and (21.4).
–Remove the window.
–Clean the window or replace it with a new
one.
–Fit the cleaned/new window. Both of the
pegs (21.1) on the window must snap into
the recesses of the upper hood as shown
in Fig. 21.
–Tighten the screw (21.5).
10

Accessories

Use only original Festool accessories and
Festool consumable material intended for
this machine because these components are
designed specifi cally for the machine. Using
accessories and consumable material from
other suppliers will most likely affect the
quality of your working results and limit any
warranty claims. Machine wear or your own
personal workload may increase depending
on the application. Protect yourself and your
machine, and preserve your warranty claims
by always using original Festool accessories
and Festool consumable material!
Festool offers you a comprehensive range of
accessories for your circular cross-cut saw:
• Saw blades for different materials.
• Trimming attachment (workpiece support
surface with integral measurement scale):
allows you to support and machine long
workpieces accurately.
• Cornice stop: support for sloping strip ma-
terial and cornices.
Other accessories and order numbers for
accessories and tools can be found in the
Festool catalogue or on the Internet under
www.festool.com.
11

Disposal

Do not throw the power tool in your house-
hold waste! Dispose of the machine, acces-
sories and packaging at an environmentally-
responsible recycling centre! Observe the
valid national regulations.
EU only: European Directive 2002/96/EC
stipulate that used electric power tools must
be collected separately and disposed of at an
environmentally responsible recycling centre.
12 Warranty
For our tools, we give warranty for material
and production defects in accordance with
the locally applicable legal provisions, but in
any case for at least 12 months. Within the
EU member states, the warranty period is
24 months (verifi cation through invoice or
delivery note). Damage caused by, in par-
ticular, natural wear, overloading, incorrect
handling, or damage caused by the operator,
or damage caused through use of the equip-
ment contrary that specifi ed in the Operating
Instructions, or damage which was known
at the time of purchase, is not covered by
the warranty. Furthermore, damage caused
by the use of non-original accessories and
consumable materials (e.g. sanding pads)
is also excluded.
Complaints can only be recognised if the
tool is returned while still assembled to the
supplier or an authorised Festool Customer
Service workshop. Keep the Operating In-
structions, Safety Instructions, Spare Parts
List and purchase receipt in a safe place.
Otherwise the respective, current warranty
conditions of the manufacturer shall apply.
Note
Due to continuous research and develop-
ment work, we reserve the right to make
changes to the technical content of this
documentation.
13 EU Declaration of Conformity
We solely declare that this product conforms
with the following standards and normative
documents: EN 61029, EN 55014, EN 61000
in accordance with the regulations in Direc-
tives 2004/108/EC, 98/37/EC (until 28 Dec.
2009), 2006/42/EC (from 29 Dec. 2009).
Dr. Johannes Steimel
Head of research and development
Festool GmbH, Wendlingen
22