Above Counter Diverter Installation (10-0188) - Amway eSpring Manual Del Propietário

A B O V E C O U NTE R D IV E R TE R
I N S TA L L ATI ON (10- 0188)
The eSpring
® Water Purifier sits on the countertop with the Diverter and tubing
attached directly to your faucet. It does not work with pull out sprayer faucets.
The tubing should be replaced every two years.
NOTE: Attach the Diverter to a
faucet that will supply COLD,
POTABLE WATER to the Water
Purifier. DO NOT RUN HOT
WATER THROUGH THE WATER
PURIFIER.
Check to make sure you have all
the correct components before
beginning installation (Fig 1).
a. Diverter
b. Tubing
c. 3 Faucet Adapters
d. 2 Tubing Supports
e. 2 Tie Straps
f. Tubing Removal Tool
AT TA C HI NG T HE DI VE RT ER
1. Unscrew to remove the aerator (wire
screen) and washer from the end of
your faucet (Fig. 2).
2. There are three options for attaching the Diverter to the faucet.
a) Position the Diverter onto the faucet and hand tighten the textured
collar counterclockwise until secure (Fig. 3).
b) If that does not fit, attach the appropriate textured adapter with inter-
nal threads and washer to the end of your faucet (Fig. 4).
c) If the threads on your faucet are internal, attach the appropriate
adapter with external threads to the end of your faucet (Fig. 5).
Fig. 3
AT TA C HI NG T HE T U B ING TO THE DIV E R TE R
1. Unscrew to remove the textured nuts (Fig. 6).
2. With the threads facing out, push the large nut onto the large tube and the
small nut onto the small tube (Fig. 7).
Fig. 6
2
1035793_eng.indd 2
Fig. 1
a
b
c
f
d
Fig. 2
Fig. 4 Fig. 5
Fig. 7
3. Firmly push the large tube onto the large
barb and the small tube onto the small
barb (Fig. 8).
4. Screw the nuts onto the barbs and hand
tighten (Fig. 9). Use the tie straps to
secure the tubing to the faucet.
e
ATTAC H ING TUB ING TO WATE R PU RIFIE R
A ND C H E CK ING FOR LE A KS
**MAKE SURE THE UNIT IS NOT PLUGGED INTO AN ELECTRICAL OUTLET.
1. Position the eSpring Wa-
ter Purifier in a desired
location where the tubing
from the faucet reaches
the Water Purifier and the
Power Adapter reaches
an outlet with continuous
power (Fig. 10).
2. Remove the Top Shroud from the Water
Purifier . Remove the Electronic
Module (Fig. 11).
3. If the tubing is too long, use a sharp
knife to cut the tubes to the same
length where they are NOT BONDED
TOGETHER.
Make sure the cut is straight to form a
flat end on the tubes (Fig. 12).
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
6/10/14 4:42 PM