Completing The Installation - Amway eSpring Manual Del Propietário

13. Screw on the Retaining Ring until
it hits a STOP. No exposed threads
should be visible below the Retain-
ing Ring. If threads are exposed,
the Bracket is not pushed all the
way down (Fig. 43).
NOTE: The Retaining Ring is not meant
to create a water seal, so Do Not rotate
past the STOP, as this may result in Car-
ton Water Treatment System damage.
14. Reinsert each tube into the proper
locations on the Bracket. Insert
tubes until they meet the marks or
the marks disappear (Fig. 44).
NOTE: You will feel resistance before the
tube is fully installed.
15. Turning on the cold water to the Water Purifier.
a) For the Existing
Faucet: Turn on the
cold water at the
faucet and pull
the Diverter pin
(Fig. 45A).
b) For the Auxiliary
Faucet: With the
Auxiliary Faucet
handle still in the
open position ,
open the supply
shut-off valve
(Fig. 45B).
NOTE: It will take a short time for water to saturate the Cartridge and flow from
the Diverter. Flush for a minimum of 5 U.S. gallons (20 liters) (approximately
5-15 minutes) to remove air pockets and carbon dust. If water is not clear, see
Troubleshotting, p. 8.
16. Check for any signs of leakage (Fig.
46).
Refer to Troubleshooting, p. 7.
17. Turn off the water to the Water Puri-
fier.
10
1035793_eng.indd 10
Fig. 43
Fig. 44
Fig. 45A
Fig. 45B
Fig. 46
C O MP LET IN G TH E
IN STA LL ATI ON
1. Replace the Electronic Module .
Store the Tubing Removal Tool for
future use (Fig. 47).
2. Push cord strain relief into notch on
Base. Make sure the tubes are in the
notches on the back of the Base
(Fig. 48).
3. Place the Top Shroud onto Base
Plug the Power Adapter into the wall
outlet (Fig. 49)
4. Wait for monitor to signal new
Cartridge with a beep. This may
take 30 seconds.
5. Turn on water to the Water Purifier
and make sure that the display has
a blue cup with rolling water drops,
p. 6 (Fig. 50). If not, refer to
Troubleshooting, p. 8.
Fig. 47
Fig. 48
.
Fig. 49
Fig. 50
6/10/14 4:42 PM
A
T
P
T
I
e
e
W