Commissioning And Operation; Adjustment; Electronic Motor Control - Festool HK 132 E Manual De Instrucciones

ance with EN 60 745:
Uncertainty
The specifi ed emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads dur-
ing operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately.
Take note of idling and downtimes of machine!

6 Commissioning and Operation

WARNING
Risk of accident if the machine is operated us-
ing unauthorised voltages or frequencies.
 The mains voltage and the frequency of the
power source must correspond with the
specifi cations on the machine's name plate.
 In North America, only Festool machines with
the voltage specifi cations 120 V/60 Hz may
be used.
WARNING
Risk of accident, electric shock
 Always pull the plug out of the socket before
performing any type of work on the machine.
Adjustment of the riving knife
WARNING
Risk of injury, if the riving knife is not
adjusted.
The riving knife [1-11] must always be used for
safety reasons. The riving knife prevents the saw
blade from becoming jammed when making length-
wise cuts.
Loosen screw [1-12], adjust the riving knife [1-11]
and retighten the screw (see figure).
2
a = 3.1 m/s
h
2
K = 1.5 m/s
Check the function of the swinging guard [1-9].
Switching On/Off
Switching On:
Press the safety button [1-14].
Press the on-off switch [1-13] and hold depressed.
Note: The on-off switch cannot be locked on.
Switching Off:
Release the on-off switch [1-13].
7
Risk of accident, electric shock
 Always pull the plug out of the socket before
performing any type of work on the machine.

7.1 Electronic Motor Control

Soft start
The electronically-controlled soft start ensures that
the tool starts without jerking and requires only a
small starting current (weaker fuses required).
Constant speed
The motor speed is electronically stabilised. This
enables a constant cutting speed even under a
heavy load.
correctly
Overload protection
In cases of extreme overload (rip cutting, use of
blunt saw blades) the power consumption may con-
siderably exceed the permissible rated value. In this
case an electronic overload device protects the mo-
tor from burning out. The motor is hereby switched
of by an "electronic safety clutch" and re-starts as
soon as the load is removed.
Temperature protection
Extreme overload in continuous operation causes
the motor to heat up. An electronic temperature
monitoring device is fi tted to prevent overheat-
ing (motor burn-out). The electronic safety device
19

Adjustment

WARNING