Bosch GCM 10 S Professional Manual Original página 29

OBJ_BUCH-1126-005.book Page 29 Wednesday, April 27, 2016 3:07 PM
Sawing with Slide Movement
– For cuts using the slide device 25 (wide workpieces), loos-
en the locking screw 26 in case it is tightened.
– Firmly clamp the workpiece as appropriate for its dimensions.
– Set the desired mitre angle.
– Pull the tool arm away from the fence 9 far enough so that
the saw blade is in front of the workpiece.
– Switch on the machine.
– Push the locking lever 4 and guide the tool arm slowly
downward with the tool handle 6.
– Press the tool arm in the direction of the fence 9 and saw
through the workpiece applying uniform feed.
– Switch off the machine and wait until the saw blade has
come to a complete stop.
– Guide the tool arm slowly upward.
Adjusting the Depth Stop (Sawing Grooves) (see figure P)
The depth stop must be adjusted when a trench gap is to be
sawed.
– Loosen both lock nuts 50 using a commercial box-end or
open-end spanner (size 14 mm).
– Loosen the knurled nut 2.
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two different ways:
– placed against the fence
– lying flat on the saw table.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Bevel angle
Floor strip/moulding
Inner corner
Horizontal mitre angle
Positioning of
workpiece
The finished work-
piece is located ...
Outer corner
Horizontal mitre angle
Positioning of
workpiece
The finished work-
piece is located ...
Bosch Power Tools
– Tilt the tool arm by the handle 6 to the position at which the
requested groove depth is reached.
– Screw adjusting screw 34 in clockwise or anticlockwise di-
rection with an hex key (8 mm) until the screw end faces
against the depth stop 51.
– Guide the tool arm slowly upward.
– First tighten the knurled nut 2 and then the locking
nuts 50.
Sawing Workpieces of the Same Length
(see figure Q)
The material stop 52 can be used for easily sawing workpiec-
es to the same length.
– Move the length stop 52 on the extension bar 45 toward
the saw blade to the desired clearance.
Special Workpieces
When sawing curved or round workpieces, these must be es-
pecially secured against slipping. At the cutting line, no gap
may exist between workpiece, fence and saw table.
Provide for special fixtures, if required.
In addition, the cut can be perfomed with or without slide move-
ment depending on the width of the profile strip/moulding.
Always make trial cuts with the mitre angle setting first on
scrap wood.
Placed
against the
fence
0°
Left side Right side
45° left 45° right
Bottom edge on Bottom edge on
saw table saw table
... to the left ... to the right
of the cut of the cut
45° right 45° left
Bottom edge on Bottom edge on
saw table saw table
... to the right ... to the left
of the cut of the cut
English | 29
Lying flat on
the saw table
45°
Left side Right side
0° 0°
Upper edge Bottom edge
against the fence against the fence
... to the left ... to the left
of the cut of the cut
0° 0°
Bottom edge Upper edge
against the fence against the fence
... to the right ... to the right
of the cut of the cut
1 609 92A 2N6 | (27.4.16)