Extracting Dust - Festool ISC 240 Li Manual De Instrucciones Original

English
7.4 Changing the serrated saw blade [6]
► Disconnect the cutting set from the power
tool.
► Remove the protective cover.
► Pull the movable saw blade [6-1] on the
single-cam shaft (T shaft) [6-2] away from
the guide rail at angle in order to remove it
from the guide rail.
Raise the fixed saw blade [6-3].
►
► Pull the fixed saw blade out of the guide
rail.
► Push a new fixed saw blade into the
guide rail.
► Push the fixed saw blade downwards un­
til the recesses in the saw blade engage
with the protrusions of the adjusting levers.
► Hold a new movable saw blade against
the single-cam shaft (T shaft) and push the
end forwards into the guide rail at an angle.
The saw blade is hooked into the end of the
guide rail.
► Fit the protective cover.
7.5 Changing a cross-set saw blade
(accessory) [7]
► Disconnect the cutting set from the power
tool.
► Remove the protective cover.
Pull the movable saw blade [7-1] on the
►
single-cam shaft (T shaft) [7-2] away from
the guide rail at an angle in order to remove
it from the guide rail.
► Hold a new movable saw blade against
the single-cam shaft (T shaft) and push the
end forwards into the guide rail at an angle.
The saw blade is hooked into the end of the
guide rail.
► Fit the protective cover.
7.6 Fitting the base adapter [8]
► If necessary, push the extractor connec­
tor [3-1] upwards.
► Release the rotary knob by one turn.
► Slide the protective cover downwards by
approx. 4 cm.
Insert the base adapter [8-1] at the end
►
of the cutting set.
► Push the base adapter towards the pow­
er tool until it latches into it at the three
latching points [8-2].
► Close the rotary knob.
18
Make sure that the base adapter [8-1]
latches into the power tool at the three
latching points [8-2].
7.7 Removing the base adapter [9]
► Push the extractor connector [3-1] upwards
if required.
► Release the rotary knob by one turn.
► Release the base adapter at the three
latching points [9-1].
► Push the base adapter downwards and
away from the tool at an angle.
► Close the rotary knob.
7.8 Changing the guide rail slide [10]
Always use the guide rail slide [10-1] in
conjunction with a guide rail and only to­
gether with the cutting set with serrated saw
blade.
► Release the lever.
► Insert the cutting set.
► Close the lever.
► Remove the protective cover.
► Place the guide rail slide on the
grooves [10-2] provided in the guide rail.
Removal is performed in reverse order.
7.9

Extracting dust

WARNING
Heath hazard posed by dust
► Always work with an extractor.
► Comply with national regulations.
The extractor connector enables the power tool
to be connected to a dust extractor (hose diam­
eter: 27 mm).
► Gently apply pressure to push the extractor
connector downwards.
The chip ejection opening on the lower part of
the extractor connector must be cleaned regu­
larly with a brush.
► Gently apply pressure to push the extractor
connector downwards.
► Clean the chip ejection opening with a
brush.