Symbols; Safety Warnings; General Safety Instructions For Power Tools; Safety Instructions For Specific Circular Saws - Festool HK 55 EBQ Manual De Instrucciones

English
Contents
1 Symbols..................................................... 16
2 Safety warnings.........................................16
3 Intended use..............................................19
4 Technical data........................................... 19
5 Machine features...................................... 19
6 Operation................................................... 20
7 Settings......................................................20
8 Working with the electric power tool........21
9 Service and maintenance..........................23
10 Accessories............................................... 23
11 Environment.............................................. 23
12 General information.................................. 24
1

Symbols

Warning of general danger
Warning of electric shock
Read the operating manual and safety
instructions.
Wear ear protection.
Wear protective gloves.
Wear a dust mask.
Wear protective goggles.
Direction of rotation of saw and the
saw blade
Do not place down any saws with ex­
posed saw blades
Do not dispose of it with domestic
waste.
CE marking: Confirms the conformity
of the power tool with the European
Community directives.
Tool contains a chip which stores data.
See section 12.1
Tip or advice
Handling instruction
Safety class II
16
Danger area! Keep hands away!
Pull out the mains plug
Disconnecting the mains power cable
Risk of pinching fingers and hands!
Electro-dynamic run-down brake
STOP
2

Safety warnings

2.1 General safety instructions for power
tools
WARNING! Read all safety warnings, in­
structions, illustrations and specifica­
tions provided with this power tool. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" used in the safety in­
structions refers to mains-powered power tools
(with power cable) or battery-powered power
tools (without power cable).
2.2 Safety instructions for specific circular
saws
- Only for AS/NZS: The tool shall always be
supplied via residual current device with a
rated residual current of 30 mA or less.
Cutting procedures
- DANGER: Keep hands away from
cutting area and the blade. Keep your sec­
ond hand on auxiliary handle, or motor
housing. If both hands are holding the saw,
they cannot be cut by the blade.
Do not reach underneath the workpiece.
-
The guard cannot protect you from the
blade below the workpiece.
- Adjust the cutting depth to the thickness of
the workpiece. Less than a full tooth of the
blade teeth should be visible below the
workpiece.
Never hold the workpiece in your hands or
-
across your leg while cutting. Secure the
workpiece to a stable platform. It is impor­
tant to support the work properly to mini­
mise body exposure, blade binding, or loss
of control.
Hold the power tool by insulated gripping
-
surfaces, when performing an operation