Parts Description - Makita AN634H Manual De Instrucciones

Do not point the ejection port at anyone in the
4.
vicinity. Keep hands and feet away from the
ejection port area.
5. Always assume that the tool contains fasteners.
6. Never point the tool toward yourself or anyone
whether it contains fasteners or not.
Do not rush the job or force the tool. Handle
7.
the tool carefully.
8. Do not activate the tool unless the tool is
9.
trigger or hand it to someone in this condition.
10. Never use fastener driving tools marked with
the symbol "Do not use on scaffoldings, lad-
— when changing one driving location to
— closing boxes or crates;
vehicles and wagons.
11.
the like carefully to avoid possible electrical
shock, gas leakage, explosions, etc. caused by
striking live wires, conduits or gas pipes.
12. Do not use the tool for fastening electrical
cables.
13. Watch your footing and maintain your balance
with the tool. Make sure there is no one below
or catching.
14. On rooftops and other high locations, drive
fasteners as you move forward. It is easy to lose
15. A fastener will be bent or the tool can become
jammed if you mistakenly drive fastener on
top of another fastener or strike a knot in the
wood. The fastener may be thrown and hit
someone, or the tool itself can react danger-
ously. Place the fasteners with care.
16. Do not leave the loaded tool or the air com-
pressor under pressure for a long time out in
the sun. Be sure that dust, sand, chips and
foreign matter will not enter the tool in the
place where you leave it setting.
17. Never attempt to drive fasteners from both the
inside and outside at the same time. Fasteners
danger.
Service
1. Perform cleaning and maintenance right after
tion. Lubricate moving parts to prevent rusting and
Keep the tool in tip-top condi-
2. Ask Makita authorized service center for peri-
odical inspection of the tool.
3. To maintain product SAFETY and RELIABILITY,
maintenance and repairs should be performed
by Makita Authorized Service Centers, always
using Makita replacement parts.
SAVE THESE INSTRUCTIONS.
WARNING:
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.

PARTS DESCRIPTION

Fig.2: 1.
4.
element)
INSTALLATION
Selecting compressor
-
140
120
100
80
2
60
-
40
20
0
0 10
1.
MPa (17.6 bar) 5. 1.18 MPa (11.8 bar)
Select a compressor that has ample pressure and air
ble pressure and compressor air output.
Pressure regulators must be used to limit air pressure to the
the tool's rated pressure. Failure to do so may result in seri-
9 ENGLISH
DO NOT let comfort or familiarity
2. 3. Hook
5. Nose adapter (contact
20 30 40
1
2.
3. 2.26 MPa (22.6 bar) 4. 1.76
3
4
5
50 60
-