Makita AN634H Manual De Instrucciones página 11

3.
the arrow points to the corresponding graduation incre-
Fig.14: 1.
NOTICE:
4. Place the nail coil over the change plate and
uncoil enough nails to reach the nail rail.
Fig.15: 1. Nail rail 2. Feed claw
5.
6.
lever locks.
Connecting air hose
CAUTION:
Do not connect the air hose with
Fig.16: 1.
A hose coupling must be installed on or near the tool in
such a way that the pressure reservoir will discharge at
the time the air supply coupling is disconnected.
Changing the trigger for contact
actuation mode
CAUTION:
Always disconnect the air hose
and unload the tool with nails before replacing
the trigger.
CAUTION:
After the trigger replacement,
always check that the tool operates properly
before actual work. Do not load the tool with any
nails before checking the function to avoid unex-
pected nailing.
tact actuation.
Fig.17: 1.
(Gray color) 2.
(Black color)
1.
Fig.18: 1.
2.
Fig.19: 1. Pin 2. Urethane washer 3.
2. 3. Arrow
An unexpected driving will
2. Air socket
3.
the housing.
Fig.20: 1. Hinged part 2.
4. Insert the pin to the hole and secure it by urethane
washer.
5.
NOTE:
OPERATION
CAUTION:
working order before operation.
CAUTION:
close the face to the tool. Also keep hands and
feet away from the ejection port area.
CAUTION:
always lock the trigger by turning the trigger lock
lever to the lock position
CAUTION:
locked when the trigger lock lever is set to the
lock position
Checking proper action before
operation
— Make sure that the tool does not operate only by
connecting the air hose.
— Make sure that the tool does not operate only by
pulling the trigger.
— Make sure that the tool does not operate only by
placing the contact element against the workpiece
without pulling the trigger.
Fig.21: 1.
(not pulled)
that the tool does not operate when pulling the
against the workpiece.
-
Fig.22
Nailing method
the trigger lock lever is provided.
.
position .
-
position .
Fig.23: 1.
11 ENGLISH
Make sure all safety systems are in
When operating the tool, do not
When not operating the tool,
.
Make sure that the trigger is
.
2. Workpiece 3.
2.