Turbo CREO SL Manual De Usuario página 38

CARBON FRAMES: In order to mount fenders on a CREO SL carbon frame, the use of a custom seat tube
„
mounted bracket (Fig. 12.11) (S182200001) to mimic the seatstay bridge and an extra long spacer to mount the
fender at the bottom bracket area are required.
Install the bracket on the seat tube. The vertical position on the seat tube will vary depending on the size of the
„
frame. For smaller sizes, the bracket may have to be positioned above the seatstays. The fender can connect
against the upper or lower surface of the bracket. (Fig 12.11).
ALLOY FRAMES: The frame features a seat stay bridge with threaded insert to allow direct fender attachment at
„
this point (Fig 12.12).
12.13
At the chainstay, place a spacer between the bottom bracket and the fender. For alloy frames, use a 5mm
„
spacer. For carbon frames, use a 10mm spacer (Fig. 12.13).
The rear fender stays are mounted by inserting the stays into the dropout holes and secured using set screws
„
(Fig. 12.14).
When mounting the fenders, the intended result is to have equal spacing (more than 6mm) between the tire and
„
fender along the entire circumference of the fender.
To protect the seat tube paint finish, we recommend applying a layer of mylar adhesive between the fender
„
bracket and the seat tube.
The maximum tire size when using fenders is 700x32c.
„
12.14
36